Panasonic DMR-ES20P Service Manual page 14

Error Code Diagnosis contents
PLEASE Unit is in termination process
WAIT
8.1.2. Special Modes Setting
Mode name
TEST Mode *All the main unit's parameters (include tuner)
are initialized.
Service Mode Setting every kind of modes for servicing.
*Details are described in "8.1.3. Service
Mode at a glance".
Forced disc eject Removing a disc that cannot be ejected.
The tray will open and unit will shift to P-off
mode.
*When Timer REC is ON, execute " Forced
disc eject " after releasing Timer REC.
While Demonstration Lock is being set, this
Forced disc eject function is not accepted.
Forced power-off When the power button is not effective while
power is ON, turn off the power forcibly.
*When Timer REC is ON, execute "Forced
Power-off" after releasing Timer REC.
Aging Perform sequence of modes as * Aging
Description shown below continually.
Aging Contents (Example):
Description
Unit is in termination process now.
"BYE" is displayed and power will be turned
off.
In case "Quick Start" of setup menu is ON, it
is displayed in restoration operation for AC
off.
Item
Description
Monitor Display
No display
FL display
The display before execution
leaves.
Display in P-off mode.
Display following the then mode.
14
Automatic FL display
Key operation
Front Key
Press [STOP], [CH UP] and [OPEN/
CLOSE] keys simultaneously for
five seconds when power is off.
When the power is off, press [CH
UP], [OPEN/CLOSE] and [REC]
keys simultaneously for 5 seconds.
When the power is off, press
[STOP] and [CH UP] keys simulta-
neously for 5 seconds.
Press [Power] key over than 10 sec-
onds.
When the power is ON, press
[STOP], [POWER] and [OPEN/
CLOSE] simultaneously for over 5
seconds and less than 10 seconds.
NOTE1:
If Unit has not turned into Aging
mode by operations shown above,
execute TEST MODE once and re-
execute operation shown above.
(*All the main unit's parameters
include tuner are initialized by TEST
mode.)
NOTE2:
If the unit has hung-up because of
pressing keys for over 10 seconds,
once turn off the power, and re-exe-
cute this command.
*When releasing Aging mode, press
[POWER] key.