Technical Specifications Of Pureit Ultima Ro + Uv Purifier; Pureit Ultima Ro + Uv's Unique Technology - PURE It Ultima RO + UV Instruction Manual

6
TECHNICAL SPECIFICATIONS OF
PUREIT ULTIMA RO + UV PURIFIER
Pureit Ultima RO + UV
Height ~486 mm
Width ~360 mm
Depth ~311.5 mm
Weight of 'Pureit Ultima RO + UV' ~9.5 kg
Flow rate* Approximately 9–12 litres per hour
Storage tank capacity 10 litres**
PP Melt Blown Pre-Sediment Filter, Pre-RO Carbon Filter,
6-Stage Purifying Technology Post-Carbon Sediment Filter, Reverse Osmosis Membrane,
UV reactor and Post-RO Carbon Filter
Membrane type Thin-film composite spiral wound
Pump type Diaphragm pump, 24V DC
% Recovery* Typically 25%
TDS reduction*** 90% (min)
Input water pH range 6.5–8.5
Power rating 60 Watts
Pressure rating 5–30 PSI****
Input Voltage 150–300 VAC, 50–60 Hz
Material of construction for plastic parts Food grade, non-toxic, engineering grade plastics
Length of Power cord 1.6 metres
Total Dissolved Solids in input water Upto 2000 mg/lit
Total hardness of input water 500 mg/lit (max)
Iron in input water 0.3 mg/lit (max)
Turbidity of input water 1
NTU (max)
Germkill Kit
TM
Material of construction Food grade, non-toxic, engineering-grade plastics
Pre-Sediment Filter – 2 Nos
Pre-RO Carbon Filter – 1 No
Germkill Kit-1
Post-RO Carbon Filter – 1 No
TDS Modulator – 1 No
Pre-Sediment Filter – 2 Nos
Pre-RO Carbon Filter – 1 No
Post-RO Carbon Filter – 1 No
Germkill Kit-2
Post-Carbon Sediment Filter – 1 No
RO Membrane – 1 No
TDS Modulator – 1 No
Meets stringent international criteria for microbiologically
Germkill performance standard
safe drinking water – e.g., Environmental Protection Agency (EPA), USA
* Permeate flow rate and recovery are based on standard test conditions and may vary depending on input water quality,
TDS, pressure and life of Filter elements.
** 10 litres of storage only with running water. Or else 9.2 litres of water dispensing.
*** Input water quality and TDS content are important determinants of output water quality.
**** If input pressure exceeds 30 PSI, please install a company provided pressure reducing valve at an additional cost. If the
pressure is lesser than 5 PSI then you need to buy 'Pressure enhancing pump' at an additional cost. Device should not
be installed in a house where input pressure is greater than 60 psi.
# Technical specifications are subject to change or improvement without prior notice.
#

PUREIT ULTIMA RO + UV'S UNIqUE TECHNOLOGY

5
6
4
2
3
1
Pre-Sediment Filter
Removes fine and coarse particulate impurities/dirt and improves the life of the Carbon Filter.
2
Pre-RO Carbon Filter
Removes chlorine and organic impurities like harmful pesticides. It also adsorbs bad taste
and odour-causing organic compounds from water.
3
Post-Carbon Sediment Filter
Removes remaining fine and coarse particulate impurities/dirt and improves the life
of RO Membrane.
4
RO Membrane
Removes dissolved salts, hardness, pesticides and heavy metals like arsenic, lead and mercury.
It also removes microbial contaminants like bacteria, virus, protozoa and cysts.
5
TDS Modulator
Adds adequate quantities of essential minerals to the purified water.
6
UV Reactor
Acts as an additional stage of purification to further inactivate bacteria, virus
and parasites to deliver safe water.
7
Post-RO Carbon Filter
Last level of purification acts as a polisher and enhances the taste of purified water.
7
1
7