Set Stations; Pal Fine-Tuning Channels Already Stored - JVC HR-E939EG Instructions Manual

Perform steps 1 and 2 of "Storing Channels Manually" on
page 38 to access the Confirmation screen before continuing.
Set Stations (A)
SELECT ITEM
1
Press PUSH JOG%fi
blinking. Then press OK twice and the station's name
(ID) begins blinking.
SELECT NEW STATION
2
Press PUSH JOG %fi until the new station's name (ID)
you want to store begins blinking.
Registered station names (
press PUSH JOG % fi.
SWITCH STATIONS
3
Press OK.
Repeat steps 1 through 3 as necessary.
CLOSE CONFIRMATION
SCREEN
4
Press CH SET.
Set Stations (B)
NOTE:
First perform step 1 of the above procedure.
SELECT STATION NAME
CHARACTER
2
Press PUSH JOG and the first letter of the station
name begins blinking.
ENTER NEW CHARACTER
3
Press PUSH JOG % fi to cycle through the characters
(A–Z, 0–9, –, * , +, (space)) and stop when the
desired one is indicated, then press PUSH JOG
enter. Enter the remaining characters the same way
(maximum of 4).
After entering all characters, press OK.
Repeat steps 1 through 3 as necessary.
If you make a mistake, press PUSH JOG
incorrect character begins blinking. Then enter the
correct character by pressing PUSH JOG % fi .
CLOSE CONFIRMATION
SCREEN
4
Press CH SET.
until the item you want begins
pg. 40) appear as you
to
until the
Fine-Tuning Channels
Already Stored
SELECT CHANNEL TO
FINE-TUNE
1
Press PUSH JOG % fi
tune begins blinking.
ACCESS MANUAL CH. SET
SCREEN
2
Press OK three times. The Manual Ch. Set screen
appears.
PERFORM TUNING
3
Press PUSH JOG% fi until the picture is its clearest.
Then press OK.
The Confirmation screen appears.
Repeat steps 1 through 3 as necessary.
CLOSE CONFIRMATION
SCREEN
4
Press CH SET.
39
EN
until the channel you want to