Flight Engineer - Kazan Helicopters Mi-17-1V Flight Manual

MI1·17·1B. Flight manual
(i)
Ma~e
sure that the engine throttle levers are intact and move
smoothly.
(l) Give an order to connect the qround power source or eneroize the
helicopter electrical system. _ . -
(k) After the Flight Engineer reports that the electrical system voltage is
OK switch on the command radio station, check the interphone
communication with all the crewmembers.
(I) At ambient temperatures of +5°C or below make sure the pitot static
tube heater indication is OK.
(m) Check the windscreen wiper (by momentary switching on until it
starts moving on the dry windscreen).
(n) Make sure the PIII·65 information reporting system switch is set to
OFF (BbIKJ1.) and the SWITCH INF REPORT ON (BKJ1f04111 Pili-
65) annunciator illuminates.
(0) Make sure the CnYY-52 tail rotor pitch limit system switch is set to
OFF (BblKJ1.) and the respective switch-light at the Flight Engi-
neer's centre control panel illuminates.
(3) During preparation for night flying, in addition to the above operations
perform the following:
(a) Switch off the white lighting before inspecting the flight compart-
ment.
(b) Switch on the red lighting of the instruments and panels.
(c) Switch on the navigation and MCJ1-3 anti-collision lights.
(d) Test the landing lights.
3.3.2. Flight Engineer
(1) On the order of the Captain the Flight Engineer should do the following;
(a) Cut in the storage batteries by selling the BATT 1-2 (AKKYMYJ11,
2) switches to ON (BKJ1.).
(b) Check the voltage at the storage battery bus by selling the wafer
selector switch to BATT BUSES (WIIIHbl AKKYMYJ1) (the voltage
should be not less than 24V).
(c) Check condition of the aircraft storage batteries proceeding in the
following way:
Set the EXT PWR (A3PO,Q nIllTAH.) selector switch to OFF
(BbIKJ1).
Set the selector switch of the DC POWER (nOCT07lHHbILll TOK)
control panel to BATT 1 (AKKYMYJ11).
Set the BATT 2 (AKKYMYJ1 2) switch to OFF (BbIKJ1).
booster pump and read the voltmeter (the voltage
not less than 24 V).
Set the wafer selector switch to BATT 2 (AKKYMYJ1 2).
Set the BATT 2 (AKKYMYJ1 2) switch to ON (BKJ1) and the BATT 1
(AKKYMYJ1 1) switch to OFF (BbIKJ1) and read the voltmeter (the
voltage should be not less than 24V).
Switch OFF the fuel booster pump.
Set the BATT 1 (AKKYMYJ11) switch to ON (BKJ1).
3-8