Control Two Jvc Vcrs - JVC HR-DD840U Instructions Manual

58
EN
A/B CODE
1
4
POWER
2 3
6
5
7 8 9
0
SPECIAL FEATURES (cont.)

Control Two JVC VCRs

The supplied remote control is capable of controlling two JVC
VCRs independently using the A/B CODE switch. You can set this
VCR so it responds to remote commands only when the switch is
set to B, and another VCR so it responds to commands when the
switch is set to A. The switch is preset to A because this VCR
normally responds to A-code signals. Follow steps 1 – 4 to set this
VCR to respond to B-code commands.
UNPLUG VCR'S POWER
CORD
1
Unplug from the AC outlet.
SET A/B CODE SWITCH
2
Set the A/B CODE switch on the remote control to B.
PLUG IN POWER CORD
3
Plug back in to the AC outlet.
TURN VCR POWER ON
4
Press POWER on the remote.
The VCR will now respond only to B-code commands.
To set the VCR to respond to A code signals again, repeat the
above procedures setting the A/B CODE switch to A, instead of
B, in step 2.
You can control two VCRs with the same remote control by
switching the remote's code between A and B.