JVC HR-A630EK Instructions Manual page 41

* OPERATE Button — same as button on recorder.
pg. 5
( DISPLAY Button switches display between
clock time and counter readings.
) ADD TIME Button adds time to end of record-
ing (5 minutes each time button is pressed.)
pg. 23
q DAILY Button enables timer recording of daily
serials. pg. 23
w WEEKLY Button enables timer recording of
weekly serials. pg. 23
e AUX Button sets recorder's input mode.
pg. 27
r TIMER Button — same as button on recorder.
pg. 23
t TV PROG. +/– Button selects preset.
y DATE +/– Button inputs date of programme for
timer recording. pg. 24
u TV/VCR Switch enables remote control of VCR
or connected TV. "Operating JVC TVs" in the
right column.
i TV/VIDEO Button switches control between TV
and VCR. "Operating JVC TVs" in the right
column.
o Fast Forward [FF] Button — same as button on
recorder. pg. 11
p PAUSE Button — same as button on recorder.
pg. 12
Q STOP Button — same as button on recorder.
pg. 11
W PROG CHECK Button accesses Program dis-
plays (next program's information display
appears each time button is pressed).
E OK Button enters display selections.
R TV VOL %fi Button controls volume of con-
nected TV. "Operating JVC TVs" in the right
column.
Installing Batteries
1
Open the battery compartment cover.
2
Insert 2 "R6"-size batteries (provided) in the correct
directions.
pg. 19
3
Replace the cover.
pg. 8
How To Use
The remote control can operate most of your video
recorder's functions, as well as basic functions of JVC TV
sets. See below.
Point the remote control toward the sensor window.
The maximum operating distance of the remote control
is about 8 m.
NOTE:
If for some reason the remote control doesn't work properly,
remove its batteries, wait a short time and then try again.
Operating JVC TVs
To operate your TV, set the TV/VCR switch to "TV". The
OPERATE button, TV/VIDEO button, TV PROG. +/–
buttons, TV VOL %fi buttons and the MUTE button on the
remote control can all be used to operate the TV.
Use the NUMBER keys, and the DIGIT ENTRY (
button or the PUSH JOG
preset.
pg. 26
The DIGIT ENTRY (
pg. 8
2-digit entry switching button (often labelled -/--) on your
TV's remote control. The PUSH JOG
to the 10+ button, and the PUSH JOG
sponds to the 20+ button of your TV's remote control.
NOTE:
The way these buttons are used is determined by your TV.
Use these buttons as instructed for your TV's remote
control.
41
)
button to select the TV's
) button corresponds to the 1-digit/
button corresponds
button corre-