Set Stations; Fine-Tuning Channels Already Stored - JVC HR-A230E Instructions Manual

SELECT NEW POSITION
2
Press PUSH JOG%fi to move the station to the new
channel position, then press OK.
Example: If you moved the station in position 3 to
position 7, the stations originally in positions 4–7 each
move up one position.
Repeat steps 1 and 2 as necessary.
RETURN TO NORMAL
DISPLAY
3
Press CH SET.
Perform steps 1 and 2 of "Storing Channels Manually" on
page 22 to access the Confirmation display before continuing.
Set Stations (A)
SELECT ITEM
1
Press PUSH JOG%fi until the item you want is
displayed. Then press OK twice and the station's name
(or "– –") begins blinking.
SELECT NEW STATION
2
Press PUSH JOG%fi until the new station's name you
want to store begins blinking.
Registered station names (
press PUSH JOG%fi.
SWITCH STATIONS
3
Press OK.
Repeat steps 1 through 3 as necessary.
RETURN TO NORMAL
DISPLAY
4
Press CH SET.
Set Stations (B)
NOTE:
First perform step 1 of the above procedure.
SELECT STATION NAME
CHARACTER
2
Press PUSH JOG and the first letter of the station
name (or " – ") begins blinking.
3
4
Fine-Tuning Channels
Already Stored
1
2
pg. 24) appear as you
3
4
ENTER NEW CHARACTER
Press PUSH JOG%fi to cycle through the characters
*
(A–Z, 0–9, –, , +, (space)) and stop when the
desired one is indicated, then press PUSH JOG
enter. Enter the remaining characters the same way
(maximum of 4).
After entering all characters, press OK.
Repeat steps 1 through 3 as necessary.
If you make a mistake, press PUSH JOG
incorrect character begins blinking. Then enter the
correct character by pressing PUSH JOG%fi.
RETURN TO NORMAL
DISPLAY
Press CH SET.
SELECT CHANNEL TO
FINE-TUNE
Press PUSH JOG % fi until the channel you want to tune
is displayed.
ACCESS MANUAL CH. SET
DISPLAY
Press OK three times. The Manual Ch. Set display
appears.
"OFF" (decoder setting) appears only with A233E or
A433E.
PERFORM TUNING
Press PUSH JOG % fi until the picture is its clearest.
Then press OK.
The Confirmation display appears.
Repeat steps 1 through 3 as necessary.
RETURN TO NORMAL
DISPLAY
Press CH SET.
23
to
until the