Installing Your New Recorder; Basic Connections; Tune The Tv To Your Video Recorder - JVC HR-A230E Instructions Manual

INSTALLING YOUR NEW RECORDER

Basic
Connections
Back of TV
21-pin SCART
connector
Aerial
terminal
21-pin SCART Cable
Mains Power
Cord
RF TEST switch
Mains outlet
Tune The TV
To Your Video
Recorder
TV Aerial
Cable
RF Cable
(provided)
RF output
channel
adjustment
screw
Back of Recorder
AV1 IN/OUT
It's essential that your video recorder be properly connected.
Follow these steps carefully. THESE STEPS MUST BE COM-
PLETED BEFORE ANY VIDEO OPERATION CAN BE PER-
FORMED.
CHECK CONTENTS
1
Make sure the package contains all of the accessories
listed in "Specifications" (
SITUATE RECORDER
2
Place the recorder on a stable, horizontal surface.
CONNECT RECORDER TO
TV
3
The connection method you use depends on the type
of TV you have.
RF CONNECTION
To Connect To A TV With NO AV Input Terminals . . .
a– Disconnect the TV aerial cable from the TV.
b– Connect the TV aerial cable to the ANT. IN jack
on the rear panel of the recorder.
c– Connect the provided RF cable between the RF
OUT jack on the rear panel of the recorder and
the TV's aerial terminal.
** Before operating the recorder, make sure the TV's
channel is set to the VIDEO channel.
AV CONNECTION
To Connect To A TV With AV Input Terminals . . .
a– Connect the aerial, recorder and TV as per "RF
CONNECTION".
b– Connect an optional SCART cable between the
AV1 IN/OUT socket on the rear panel of the
recorder and the TV's 21-pin SCART connector.
c– Set the RF TEST switch to OFF.
Before operating the recorder, make sure the TV is set
to the VIDEO (or AV) mode.
CONNECT RECORDER TO
MAINS
4
Plug the end of the mains power cord into a mains
outlet.
The video recorder sends picture and sound signals via the RF
connecting cable to your TV on UHF channel 36.
TURN ON THE RECORDER
1
Press OPERATE.
SELECT OUTPUT MODE
2
Set the RF TEST switch on the back of the recorder to
ON.
3
pg. 32).
CONTINUED ON NEXT PAGE.