Table of Contents
Advertisement
NAMES AND FUNCTIONS
OF PARTS
MENU
Mini
SEARCH–
MIC
HOLD
PHONES
0
[REC LEVEL] Volume for audio
recording level for CH1/3 and
CH2/4
Use the switch to adjust the audio recording level
for CH1 and CH2.
During audio dubbing, the audio recording level
for CH3 and CH4 can be adjusted with this
switch.
Memo
● During DV input, the volume control is not
effective.
● During MIC input, only the volume for CH1/3
REC LEVEL is valid.
!
[PHONES] terminal
This is the mini jack terminal for connecting to
the headphone. (Stereo ø3.5)
• When BR-DV6000 plays back tapes recorded
in the 32 kHz mode, the audio channel for
outputting from this terminal is selected with
the 6 AUDIO OUTPUT switch.
@
[PHONES] Headphone volume
Use this switch to adjust the output level of the
PHONES terminal.
Both channels are adjusted at the same time.
#
[MIC] terminal
This is the mini jack terminal for monaural mi-
crophone input.
To input sound from a microphone, set the IN-
PUT SELECT switch to LINE or Y/C (CPN).
If a microphone is connected, sound for the AU-
DIO IN terminal located on the rear panel can-
not be input.
The sound of the microphone is recorded to
CH1/CH2 in the recording mode and CH3/CH4
in the audio-dubbing mode.
E-14
RESET
DISP
PROFESSIONAL
SET
SEARCH+
BLANK
CUE UP
REC LEVEL
BR-DV6000
CH-1/3
CH-2/4
– Front panel – (continued)
A.DUB
REC
EJECT
REW
AUDIO
COUNTER
MONITOR OUTPUT
CTL
L
CH-1/2
TC
MIX
MIX
UB
R
CH-3/4
$
[HOLD] button
If this button is pressed in the LCD enlarged
display mode, the time code preset screen will
be displayed on the LCD. When the time code
preset screen is displayed, press this button to
return to the normal display.
☞
(
Page 59 "Presetting time code")
%
[MENU] button
If this button is pressed when BR-DV6000 is in
the STOP/STILL mode or when no cassette is
loaded, the menu is displayed on the LCD or
the monitor connected to the VIDEO MONITOR
OUT terminal.
When the menu is displayed, press this button
to return to the normal display.
☞
(
Page 70 "Setting the menu")
^
[RESET] button
• To reset the CTL counter display to "00", press
this button.
• If this button is pressed when the time code
preset screen is displayed, all the digits of
the time code or the user's bit are reset to
"00".
• When the Multi Cue-up screen is displayed,
press this button to clear the registered cue-
up points.
&
[CUE UP] button
8
When the
COUNTER switch is set to TC,
press this button to display the Multi Cue-up
screen on the monitor or LCD.
When the Multi-Cue-up screen is displayed,
press this button to start searching the selected
tape position.
☞
(
Page 54 "Multi Cue-up")
OPERATE
PLAY
PAUSE
STOP
FF
INPUT
SELECT
REMOTE
DV
LINE
Y/C
LOCAL
(CPN)
Advertisement
Table of Contents
