Graco GM3500 SPRAYER 231-078 Instructions And Parts List page 29

REASSEMBLY
5.
Place the'engine (1) assembly on the cart, aligning
the mounting holes, and carefully guiding the engine
through theappropriategrommets (66) in the mount-
wire (D) and wiring harness (29) from the field,
ing plate (E). Secure the engine with the capscrews
clutch housing
(2)
with the capscrews (15), lock-
(14), lockwashers (9) and nuts (61). Secure the
washer (80) and washer (34). Under the mounting
plate, connect the engine wire to the red wire and
connect the black and white wires. See Fig 29-1.
6. Making sure the face of the rotor (4b) and the field is
free of all oil and contaminants, install the rotor,
lockwashers (11) and capscrews (16). Torque the
capscrews to 6.5 to
7.5
ft-lb
(8.8
to 10 Nm). See
Fig 29-1.
After installing the rotor (4b), pull the engine recoil
rope to assure that the engine turns over and there is
no friction between the rotor (4b)
and the field (6). If
there is friction, recheck the clamp dimension. See
Step 3 on page 29.
7. Making sure the face of the armature (4a) is clean,
assemble the armature to the shaft in the pinion
housing (1 9n) until the armature contacts the ring
(19k). See Fig 29-1.
8. Assemble the pinion (19) to the clutch housing using
capscrews (10) and lockwashers (1 1). See Fig 29-1.
I t
VIEW FROM
UNDERSIDE OF ENGINE
MOUNTING PLATE
Fig 29-1
. -
307-893 29