System Setup (Volume, Beep, Etc.) - Canon DC330 Instruction Manual

~
SYSTEM SETUP
[WL.REMOTE]
[SPEAKER VOL.]
•
[BEEP]
[ 18m
HIGH VOLUME],
• • • •
[18>
LOW VOLUME], [mJ OFF]
[POWER SAVE] . [m ON], [mJ OFF]
• • • •
..........
[@
STANDBY OFF]
[m.
10
min], [mm
20
min],
• •
[mllIIlI
30 min]
[FILE NOS.] [13 RESETl, [= CONTINUOUS]
•
[TV TYPE] [mJ NORMAL
TVl,
[ 0 ] WIDE TV]
• • • •
[FIRMWARE]
•
[WL. REMOTE]: Allows the camcorder to be operated with the wireless controller.
[SPEAKER VOL.]: Adjust (.....
~)
the volume of the playback.
[BEEP]: A beep will accompany some operations like turning on the camcorder, the self-
timer countdown, etc. It also serves as a warning beep under unusual conditions.
[POWER SAVE]: In order to save power when the camcorder is powered by a battery
pack, it will automatically shut off if left without any operation for 5 minutes. Approximately
30 seconds before the camcorder shuts off, the message" &AUTO POWER OFF" will
appear.
[@)
STANDBY OFF]: Select the length of time after which the camcorder will end the
standby mode and shut off automatically.
[FILE NOS.]: Select the image numbering method to be used when you insert a new
memory card.
Images are automatically assigned consecutive image numbers from 0101 to 9900, and
stored in folders containing up to 100 images. Folders are numbered from 101 to 998.
[13 RESET]: Image numbers will restart from 101-0101 every time you insert a new
memory card.
[= CONTINUOUS]: Image numbers will continue from the number following that of the
last image recorded with the camcorder.
• If the memory card you insert already contains an image with a larger number, a new
image will be assigned a number one higher than that of the last image on the memory
card.
• We recommend using the [= CONTINUOUS] setting.
[TV TYPE]: In order to display the picture in full and in the correct aspect ratio, select the
setting according to the type of television to which you will connect the camcorder.
[~
NORMAL TV): TV sets with 4:3 aspect ratio.
[mE WIDE
TV):
TV sets with 16:9 aspect ratio.
[FIRMWARE]: You can verify the current version of the camcorder's firmware. This menu
option is usually grayed out.
Additional Information • 77
I