Problem Solving Guide; Fault Messages In The Display - Miele T 8929 WP Operating Instructions Manual

Problem solving guide

With the help of the following notes, minor faults in the performance of the
machine, some of which may result from incorrect operation, can be put right
without contacting Miele. A call-out charge will be applied for unnecessary service
visits where the problem could have been rectified as described in these
Operating instructions. Please note:
,
Repairs to electrical appliances should only be carried out by a suitably
qualified and competent person in strict accordance with current local and
national safety regulations. Repairs and other work by unqualified persons
could be dangerous. The manufacturer cannot be held liable for unauthorised
work.

Fault messages in the display

Problem
You are asked to enter a
code.
Adjust the load
1
The programme is
cancelled and the
buzzer sounds.
Empty the container
2
The programme is
cancelled and the
buzzer sounds.
Possible cause
Access via a code has
been activated.
This is not a fault.
In some programmes, if
the drum has been
overloaded or
underloaded, the
programme will be
cancelled. This can also
happen if the items are
already dry.
The condensed water
container is full or there is
a kink in the drain hose.
Problem solving guide
Remedy
Enter the code (see
"Settings menu").
Use the Warm air
programme to dry
individual items.
– Open and close the
door.
– Empty out the
condensed water
container or check the
drain hose.
To clear the display:
– Switch the dryer off
and then on again.
39