Table of Contents
Advertisement
Note: If Rear Exhaust application is chosen, secure Exhaust Adaptor (Hardware item No. 6) on the back of
bracket assembly with two screws (Hardware item No. 5). Check that the damper blade
smoothly, and opens fully as shown. (Fig. G-1)
INSTALLATION OF BRACKET
1. Align the bracket assembly against the wall top cabinet. (Fig. G-2)
2. Mark holes that lie on the wall studs for wood screw and other holes, do not lie on the wall studs for toggle
bolts. (Fig. G-2 or G-3)
3. Drill
/
" holes for wood screws and
3
16
4. Secure the bracket assembly on the wall with wood screws and / or toggle bolts. (Fig. G-2 or G-3)
INSTALLATION OF OVEN
1. Remove contents from inside the oven including glass tray and wire rack.
Be sure to close the door. Remove all contents from upper kitchen cabinet.
2. Before sliding the oven on the bracket assembly, be sure that the power supply cord will be accessible through
the cabinet.
3. Lift and install the oven onto the bracket by sliding it over the rails of the bracket. This is easily and safely
accomplished with one person on each side of the oven. Push the oven all the way back until it is flush with the
wall.
Pull the power supply cord through and be careful not to pinch it between the outer case of the oven and
bottom of the cabinet. The oven should fit snugly underneath the lip of the bracket's upper edge. (Fig. G-4)
4. Insert the two screws 5 X 80 mm with flat washers (Hardware items No. 3 and No. 4) through the holes drilled
through the top cabinet's bottom and into the top of the oven. (Fig. G-5)
While tightening these screws, lift the front side of the oven and push it toward the wall. This ensures a flush
and level mounting.
Note: If Top Exhaust application is chosen, mount Exhaust Adaptor (Hardware item No. 6) on top of the oven
by using 2 screws (Hardware item No. 5) and through the cutout of the cabinet. Then connect the house
duct pipe to the exhaust adaptor.
H INSTALLATION CHECK LIST
1. Make sure the unit has been installed according to these instructions.
2. Remove all packing materials from the oven.
3. Replace house fuse or turn circuit breaker back on.
4. Plug power cord into receptacle.
5. Read operating instructions before testing the product.
6. Keep these installation instructions for the local electrical inspector's use.
/
" holes for toggle bolts. (Fig. G-2 or G-3)
3
8
Power supply
cord
Bracket
assembly
Fig. G-4
moves
A
Fig. G-5
Page 7
Advertisement
Table of Contents
