Table of Contents
Advertisement
B INSTALLATION HARDWARE
The installation hardware (1~ 8) packed with the products should include the following:
1
2
3
4
You will find the installation hardware taped on the packaging.
C INSTALLATION PROCEDURE
1. Prepare the product according to instructions.
2. Read mounting information and prepare top cabinet and wall.
3. Prepare exhaust duct, if required.
4. Attach template on the cabinet bottom and rear wall.
5. Drill holes properly into the cabinet bottom and rear wall.
(Make the exhaust port in the cabinet bottom or rear wall, if required.)
6. Mount the bracket assembly to the wall.
7. Install the oven.
8. Secure the product to top cabinet.
9. Test
D PREPARATION OF PRODUCT
1. Remove the bracket assembly located on the rear of oven and remove all adhesive tape.
2. Exhaust Preparation: Select the type of ventilation required for your installation, and proceed to the following
instructions.
a. Top Exhaust
b. Recirculating (Non vented, Ductless)
c. Rear Exhaust
a. Top Exhaust
This product is shipped ready for top exhaust ventilation mode use without modifying the product.
Securring Exhaust Adaptor (Hardware item No. 6).
Remove two blower plate mounting screws, and put Exhaust Adaptor aligning two screws hole. Secure
Exhaust Adaptor with two screws (Hardware item No. 5). (Fig. D-a-1)
Check that the damper blade A moves smoothly, and opens fully.
5
6
7
blower
A
Fig. D-a-1
No.
NAME
Wood Screw 5 X 45 mm
1
Toggle Bolts 5 X 60 mm
2
Screw 5 X 80 mm
3
Flat Washer
4
Screw (For Exhaust Adaptor and
5
Ventilation Exhaust Cover) 4 X 10 mm
Exhaust Adaptor
6
Ventilation Exhaust Cover
7
A
Page 2
QUANTITY
4
4
2
2
4
1
2
Advertisement
Table of Contents
