Tone2 Saurus ANALOG SYNTHESIZER Reference Manual page 17

Arp/Step+- : Applies the arp's velocity steps as modulation source using both positive and
negative values
Key up : Applies a On/Off Gate modulation; i.e, on key press its value is 1, on release it's 0
Key down : Applies a Off/On Gate modulation; i.e, on key press its value is 0, on release its 1
VoiceOut : Applies the amount of active Voices value to modulate
Constant: Applies a constant value to modulate, the amount is set by the value slider
Random : A random value will be used to modulate
Flipflop : An on/off value will be used as modulation source; could for example be used to pan
from left to right on keypress
WhiteNoise : Uses white noise as modulation source
PinkNoise : Uses pink noise as modulation source
Impulse : A short impulse is used as modulation source; could for example be applied to sharpen
the attack portion of a sound
Decay4ms > Decay16s : Decay will use an internal envelope to modulate, options are envelopes
that run from 4 milliseconds to 16 seconds.
X*X : Uses the X multiplied by X value modifier as modulation source
Sqrt (X) : Uses Squareroot X value modifier as modulation source
Filter (X) : Uses the filter X value modifier as modulation source
Limit (X) : Uses the Limit X value modifier as modulation source
Key : Uses the played note value as modulation source
Velocity+ : Uses the postive Velocity values to modulate
Velocity+- : Uses both the positive and negative Velocity values to modulate
Modwheel : Uses the Modulation Wheel as modulation source
Pitchwheel : Uses the Pitch Wheel as modulation source to modulate
Aftertouch : Uses the keyboard's incoming aftertouch values to modulate
Breath : Responds to breath controller (CC#2) as modulation source
Foot : Responds to Foot switch controller as modulation source
MainVol : Responds to Main Volume controller (CC#7) as modulation source
Express : Responds to Expression controller (CC#11) as modulation source
-14-