Operation In Start Mode; Cleaning - ARIETE Evolution 2.0 User Manual

OPERATION IN START MODE
Once the charge cycle has been completed, the appliance display will read "FULL" and it will be possible
to start the Robot and the cleaning cycle. To start the Robot, first check its status
"Pause"
"Stand-by"
a) If the Robot is in "pause" (it does not move and the icons 2-3-5-6 are flashing), this means that it
is waiting for commands:
- to start the cleaning cycle, press the "CLEAN" button once or if necessary, press one of the buttons on
the control panel (B) on the appliance body:
- to set the Robot from "pause" to "stand-by" hold down the "CLEAN" button for 3 seconds or wait 20
seconds until the flashing icons switch off.
b) If the Robot is on "stand-by" (it does not move and the icons and "CLEAN" button are off), this
means it is on but that it needs to be activated before it can receive commands. To start the cleaning
cycle, press the "CLEAN" button twice:
- once to activate it and set it in "pause" mode: the icons 2-3-5-6 will start to flash;
- a second time to activate cleaning setting it to "cleaning": the "CLEAN" button will switch on.

CLEANING

Once the cleaning cycle has been activated, to stop it, press the "CLEAN" button once< the icons will
begin to flash again.
- press it once to set the appliance to "pause", waiting 20 seconds for it to enter "stand-by" mode automati-
cally;
- hold down for 3 seconds to set the Robot directly in "stand-by" mode.
Lights
"CLEAN" button on and 2-3-5-6
icons flashing
"CLEAN" button and 2-3-5-6
icons off
- 29 -
Robot status
In pause mode, waiting for com-
mands.
ON (switch (Q) set to ON) but it
needs to be activated before it can
accept commands.
EN