Programming The Playing Order Of The Tracks - JVC MX-KB15 Instructions Manual

Programming the Playing Order
of the Tracks
You can program the playing order of the tracks on all the CDs.
Note that you can only make a program when the CD Player is
stopped.
❏ You can program up to 60 tracks in any desired order including
the same tracks.
To Make a Program
1
Load CDs
2
In Stop mode, set the CD Player in Program
Play mode.
On the Unit
Press the PROGRAM button, and the "PROGRAM" indicator
blinks on the display.
On the Remote Control
Press the PROGRAM/RANDOM button , and the "PROGRAM"
indicator blinks on the display.
Each time you press the button, the display changes as follows:
PROGRAM = RANDOM REPEAT = Blank display (Normal
Play) = (back to the beginning)
• If a program is already made, the last step of the program will
be displayed.
3
Press one of the Disc button (CD1-CD3) to
select the CD you want to program.
The display will change to the Program Entry display.
or
Disc number
4
Select the track you want to program.
Using the Unit
While the display is blinking, press the 4 or ¢ button to select
the track, then press the SET button.
The program order number will be assigned from P-1.
Track number
Disc number
Using the Remote Control
Press the numeric keys to directly enter the track number. Then,
the program order number will be assigned from P-1.
5
Repeat steps 3 and 4 to program other tracks
on the same CD or the other CD.
6
To play the program, Press the CD
ton.
For details, see "To Play the Program You Have Made" men-
tioned below.
To confirm the programmed contents, while the CD player
is stopped, press the SET button.
To delete all the tracks in the program, while the CD Player
is stopped, press the CANCEL button.
• If you try to program a track number that does not exists
on the CD, your entry will be ignored.
• If you try to program the 61st track, "FULL" appears on
the display.
To Play the Program You Have Made
Press the CD 6 button.
The System plays the tracks in the order you have programmed
them.
• To use Repeat Play for Program Play, press the REPEAT but-
ton to select "ALL" or "1" before starting playback. For details,
see "Repeating Tracks" on page 15.
❏ You can skip to a particular program track by pressing the 4
or ¢ button during Program Play.
❏ To stop playing, press the 7 button once.
To Exit and Re-enter Program Play
The program you have made is stored in memory. So, you can exit
Program Play temporarily or re-enter Program Play unless you de-
lete the program.
To exit the program mode once, while the CD Player is
stopped, press the PROGRAM button on the Unit or the PRO-
GRAM/RANDOM button on the Remote Control to light off the
"PROGRAM" indicator. By changing the source to the other (e.g.
Tuner), the CD Player also exits Program Play mode.
To re-enter Program Play mode, press the PROGRAM or
PROGRAM/RANDOM button until the "PROGRAM" indicator
blinks again.
• Even when the power is turned off (standby mode), the
programmed tracks are not deleted. So, you can re-enter
Program Play mode.
Program order
number
Using the CD Player
6
but-
14