Apex Digital HT-180 Operating Manual page 15

Connecting to a TV using an RF Modulator
Connection 2
Connecting the TV, unit, RF Modulator
and Cable or Satellite Box
1) Connect the three-terminal composite video
cable to the back of your Apex Home Theater
System . This cable has three prongs, one each
in yellow, red, and white. The yellow prong will go
into the jack labeled "Video Out"; the white prong
will go into the jack labeled "AUDIO L OUT"; the
red prong will go into the jack labeled "AUDIO R
OUT".
2) Connect the opposite end of the composite
video cable into the back of the RF modulator.
Make sure to match up the colors correctly.
3) Connect a coaxial cable from the "Antenna
Out" jack on the back of your Satellite receiver
to the "Antenna" jack on the RF modulator. The
coaxial cable is the one-wire, metal-ended type
that you screw onto the Cable or Satellite Box.
Connection 3
Connecting the TV , unit, VCR,
RF Modulator and Cable or Satellite Box
1) Connect the three-terminal composite video
cable to the back of your Apex Home Theater
System . This cable has three prongs, one each
in yellow, red, and white. The yellow prong will go
into the jack labeled "Video Out"; the white prong
will go into the jack labeled "AUDIO L OUT"; the
red prong will go into the jack labeled "AUDIO R
OUT".
2) Connect the opposite end of the composite
video cable into the back of the RF modulator.
Make sure to match up the colors correctly.
3) Connect a coaxial cable from the "OUT" jack
on the back of your satellite receiver to the "IN"
jack on the back of your VCR. The coaxial cable
is the one-wire, metal-ended type that you screw
onto the VCR.
4) Connect a coaxial cable from the "OUT" jack
on the back of your VCR to the "Antenna" jack on
the RF modulator.
14
A P E X D I G I T A L
Figure 2
4) Connect a coaxial cable from the "To TV" jack on the RF modulator to the
jack on the back of your TV.
5) Make sure your TV is set to the appropriate channel before using your
Home Theater System . In most cases, this is channel 3 or 4.
Figure 3
5) Connect a coaxial cable from the
"To TV" jack on the RF modulator to
the jack on the back of your TV.
6) Make sure your TV is set to the
appropriate channel before using
your Home Theater System . In most
Continued
cases, this is channel 3 or 4. Also
make sure that the VCR is set to
the appropriate channel, as well.
This selector is usually on the
back of your VCR. Consult your
VCR manual for further informa-
tion.
H T - 1 8 0