Using The Metronome; Menu Settings/Setting Values - Zoom R8 Operation Manual

Using the metronome

You can change the volume, tone and
stereo position of the metronome and use
its pre-count function. You can also set it
to only be heard through headphones.
1
Press
2 Select METRONOME.
Press
3 Select each menu item and adjust the
settings.
HINT
Use the METRONOME
the metronome output
Metronome settings are saved for each project.
You can use the metronome even when playing
back the master track.
20
Change menu
Change menu
Change setting
switch to change and adjust
.
OUTPUT + PHONES
The metronome sound is output through
both OUTPUT and PHONES jacks.
PHONES ONLY
The metronome sound is output only
through the PHONES jack.
Use the BALANCE knob to adjust the
relative volumes of the MASTER fader
signal and the metronome sound.
MASTER
CLICK
(metronome)
Menu settings and setting values
ON/OFF: Set when operative
Settings
Play Only During playback only
Rec Only During recording only
Play & Rec During both playback and recording
Off (default) No metronome sound
LEVEL: Set the volume
Setting range
0–100 Default: 50
PAN: Set the stereo position
Setting range
L100 – R100 Default: Center
SOUND: Set the sound
Settings
Bell (default) Click with bell accent
Click Click sound only
Stick Drum stick sound
Cowbell Cowbell
Hi-Q Synthesized click sound
Track1 – Track8 TRACK 1–8 sound (mono)
Track1/2 – Track7/8 TRACK 1/2–7/8 sound (stereo)
PRE COUNT: Set the count-in length
Settings
Off None (default)
Enable pre-count sound for
1–8
1–8 beats.
Special
NOTE
● Be aware that if the metronome volume is
set high, the accented beat of some sounds
might become difficult to distinguish.
● If a track with a rhythm pattern assigned to
it is selected in the SOUND
will be output.
● The metronome follows the time signature
used in the track sequencer.
setting, no sound