Pioneer DEH-P3370XM UC Service Manual page 78

DEH-P3370XM
4.6 ERROR CODE
Display format: [ERROR_XX].
_: Spacing character.
X: Error occurring (two digits of hexadecimal value). The upper digit is for the major (physical) error, while the
lower digit is for the minor error (temporary or partial errors). Refer to the following table for details:
Code value Description
Major Minor
0 No Error
CDEC Communication Error
1
SSDEC Communication Error
2
SSDEC No Response
3
No Signal
4
Activation Required
5
6 Authorization Required
0 No Error
1 ANTENNA No Connect
2 ANTENNA Short
3 PLL UNLOCK
4 Reserved
5 NVM Error
6 CAP Error
7 Version Unknown
Display example: If the antenna is not connected, the display will show [ERROR_14]
(no signal due to unconnected antenna).
4.7 SAT1-BER-INFO
Display format: [1_X. XXEY].
X: Bitabi signal decryption error rate (effective three digits).
Y: Truncated binary exponential (with negative sign abbreviated) of the error rate.
_: Spacing character.
The information becomes effective following the initialization of CDEC. The updating interval is 432 ms. If the
wave's modulated signal cannot be received (meaning such a signal cannot be locked on), a hyphen ("-") will be
displayed.
Display example: If the error rate is 0.560%, the display will show [1_5.60E3].
4.8 SAT2-BER-INFO
Display format: [2_X. XXEY].
X: Bitabi signal decryption error rate (effective three digits).
Y: Truncated binary exponential (with negative sign abbreviated) of the error rate.
_: Spacing character.
The information becomes effective following the initialization of CDEC. The updating interval is 432 ms. If none
of wave's modulated signal can be received (meaning such a signal cannot be locked on), a hyphen ("-") is
displayed.
Display example: If a signal cannot be locked on, the display will show [2_------].
78
Error location
No minor error.
The line for communicating with CDEC.
The line for communicating with SSDEC.
No SSDEC response (DSP core freeze).
100% error of Bitabi signal decryption.
Not activated.
Not authorized.
No major error.
Antenna not connected.
Shorted antenna cable.
PLL cannot be synchronized (RF circuit failure).
Undefined.
Defective NVM inside CAP.
Defective CAP (including situations where CAP is not
connected).
Unknown DSP core software version.