Listening To Fm And Mw Broadcasts; Tuning In A Station; Presetting Stations; Tuning In A Preset Station - JVC LVT0862-001B Instructions Manual

Listening to FM and MW Broadcasts

Tuning In a Station

1 When the unit is turned on,
press TUNER/BAND to
select tuner mode.
The unit tunes in the last station
tuned in (either FM or MW).
2 Press TUNER/BAND to
select the band, FM or MW.
Each time you press the button, the
band selection alternates between
FM and MW.
3 Press and hold 4 or ¢
for more than 1 second.
The unit starts searching for stations
and stops when a station of sufficient
signal strength is tuned in.
If a program is broadcast in stereo,
the STEREO indicator lights up.
To stop searching, press 4 or ¢.
When you press 4 or ¢ briefly and repeatedly
The frequency changes step by step.
To improve the FM reception
When an FM stereo broadcast is hard to
receive or noisy, press REPEAT ST/
MONO to switch to the monaural
reception. The STEREO indicator
disappears from the display.
To restore the stereo reception, press REPEAT ST/MONO
again so that the STEREO indicator lights up.

Presetting Stations

You can preset 20 FM and 20 MW stations.
BAND
TUNER • There is a time limit in doing the following steps. If the
setting is cancelled before you finish, start from step 1
again.
1 Tune in the station you want to preset.
BAND
TUNER • See "Tuning In a Station" on the left.
2 Press PROGRAM.
The PROGRAM indicator and "00"
start blinking on the display.
SEARCH/TUNING
3 Press PRESET ∞ or 5 (or
PRE DOWN 8/2 or PRE
UP 3/8 on the remote
control) to specify the
desired preset number.
4 To preset more stations, repeat steps 1 to 3
above, allocating a different preset number to
each station.
When a new station is stored
The station previously memorized with the same preset
ST/MONO
number is erased. (The frequency of the new station replaces
REPEAT
the previous frequency in memory.)

Tuning In a Preset Station

1 Press TUNER/BAND to
select tuner mode.
2 Press TUNER/BAND to select the band, FM
or MW.
3 Press PRESET ∞ or 5 (or
PRE DOWN 8/2 or PRE
UP 3/8 on the remote
control) to select the desired
preset number.
– 10 –
PROGRAM
PRESET
DIRECTION PLAY/PAUSE
BAND
TUNER
PRESET
DIRECTION PLAY/PAUSE