Advertisement
Using YOYOCam G2
Users interact with YOYOCam using SMS commands and voice calls. There are three levels of access – MASTER,
USER & GUEST:
MASTER
There is one Master user who has complete control over YOYOCam. Master-only commands:
Text to send
#00#
#14#NewMasterNumber#
#04#OldPassword#NewPassword#
#06#UserNumber#
#113#UserNumber#
#106#EmergencyNumber#
#107#EmergencyNumber#
#127#LanguageCode#
For example, send #04#1234#6789# to change password to 6789. Send #06#0702222222# to add 0702222222
as a user.
MASTER & USER
Up to 10 Users set up by the Master can access YOYOCam. Master and Users can send these commands:
Text to send
#01#
#02#
#03#
#03#Quantity#
#07#
#09# or #09#1#
#32#Size#
#33#Quantity#
#118#0# or #118#1#
#22#0# or #22#1#
#39#0#
#39#1#
#143#0# or #143#1#
Master & Users can also call YOYOCam and listen in via the built-in microphone.
GUEST
Guest users are people who do not normally need access, but might be asked to check the protected area because
they are nearby, for example. Guest users do not need to be pre-defined to YOYOCam, but do require the PIN.
Guest commands:
Text to send
#03#Password#
#03#Password#Quantity#
#30#Password#To#Quantity#
Note 1: Maximum Quantity is limited to 2 when image size is set to 3.
What it does
(after factory reset) sender becomes Master
Change from present Master number to NewMasterNumber
Change the Guest password (default is 1234)
Add a User.
Delete a User
Add Emergency Number (called when emergency button pressed on remote)
Delete Emergency Number
Set Language. 0=Swedish (default); 1 = English
What it does
Arm YOYOCam (if an event is detected, alarm is triggered)
Disarm YOYOCam (events will be ignored)
Take one image and send it to the requesting user
Take a number (Quantity 1-8) of images and send to requestor
Check the settings and status
Get the command list (#09# for SMS, #09#1# for MMS response)
Set image size: 1: 160x128; 2: 320x240 (default); 3: 640x480
Set quantity of images to take when triggered: 1-8 (default 3; note 1)
Disable (0) infrared body detection; enable (1) (default)
Disable (0) camera based motion detection (default); enable (1)
Call mode – When Emergency button pressed, numbers are dialed
SMS/MMS mode – when Emergency button is pressed, YOYOCam sends SMS and MMS.
Disable (0) indicator LED; enable (1) (default)
What it does
Take one image and send it to the requesting guest
Take a number (Quantity 1-8) of images (note 1)
Take a number (Quantity 1-8) of images and send to a phone or E-mail
address (To is the mobile number or E-Mail address; note 1)
Advertisement
