AAton XTR User Manual page 50

this flat with the two flats on the threaded portion of the Lemo.
• 6 - Replace the rubber gasket and the PBX cover plate via the four
allen screws. Double-check that the Lemo14 sits flush against the lip
of the circular opening in the cover plate.
• 7 - Plug the control unit into the PBX and fasten it to the body
with three allen screws. Connect a BNC cable to a monitor and po-
wer the XTRprod. Turn on the toggle switch of the CCD assist; the
yellow diode should light. You should also see an image of the vie-
wing screen on the monitor. If this is not the case, the beamplitter
may be retracted. Remove the beamsplitter access cap on the battery
side of the camera and position the beamsplitter by rotating the ad-
justment screw approximately 30 turns counter-clockwise until it
reaches its stop. Back off the stop one turn clockwise.
• 8 - Locate two allen head screws on the CCD head identified by a
red dot (marked A above). Loosen the screws 1/2 a turn. While loo-
b
a
king at the monitor, gently move the CCD head until the viewing
screen image is in focus. Notice that this adjustment also affects
image rotation. When sharp, even focus is achieved and the image is
square to the monitor, tighten the two screws.
50