Kawai CN25 Owner's Manual page 46

Assembly Instructions
1. Assembling the side panels b,
and pedal board d
Unfasten and extend the pedal connection cable attached to
the bottom of the pedal board d.
Attach the pedal board d to the left and right side panels b
using the alignment screws located on either end of the pedal
board. Ensure that the correct side panel is used for the left
and right side.
Ensure that the pedal board and side panels make close
contact, and that there are no large gaps between the
assembled parts.
Insert the four short silver tapping screws j into the holes as
shown, and securely fasten the pedal board to the and left and
right side panels.
b
b
b
Pedal cable
b
j
Alignment screw
j
46
b
d d
gap
b
d d
d
d
Unfasten
d
2. Attaching the back board c
Allow the assembled pedal board and side panels to stand
upright (vertically) on the floor.
* Ensure that the adjustor bolt is attached to the pedal board.
Temporarily fix the back board c to the left and right side
panels using the two long black or silver tapping screws h,
leaving a tightening allowance of approximately 1 - 2 mm.
Then attach the bottom of the back board to the pedal board
using the four mid-length black or silver tapping screws i.
Finally, retighten the long screws so that the back board will
come into tight contact with the side panels, without any
clearance left between them.
b
h
b
i
not aligned
b
c
i
i
i
h