Foreword Safety instructions • Do not cover the cable with a carpet or other objects. Congratulations on purchasing the BONECO 2055 / • Read the instructions for use carefully before putting Place the unit so that you cannot trip over the cable (6). BONECO 2055D Air Washer! the appliance into operation, and keep in a safe place • Do not operate the appliance in rooms containing for later reference. flammable goods, gases or vapours. Did you know that excessively dry indoor air • Connect the appliance to an AC supply only with a • Do not place the appliance in the rain, and do not use it • dries out mucous membranes and causes chapped lips voltage that corresponds to the rating plate on the unit. in damp rooms. and stinging eyes? • Only use the air humidifier in living spaces and within • Do not insert any foreign objects into the unit. • promotes infections and diseases of the respiratory the specified technical data. Incorrect use may be • Ensure that the air inlet is unobstructed at all times. tract? dangerous to health and life . • Never sit on the unit, and do not place any objects on it • leads to weariness, tiredness and poor concentration?
Unpacking How it works • Remove the appliance carefully from the packaging. Your appliance Warning: The upper part is only placed loosely on the • washes and humidifies the air without using filter mats base (10 – 12). • works quietly in two operation modes • Remove the plastic bag from the unit (13). • is manufactured from highquality, longlife • Check the details of the mains supply on the rating components. plate (14). • has a large cleansing capacity through preionisation. • Use the original packaging to store the appliance if you The individual dust particles are ionised (charged) and do not use it throughout the year. stick to the humidifier disks. Putting into operation Special humidifying disks rotate in a water bath inside the The best location for your appliance is: unit; this cleanses the air passing over them of impurities • On the floor, or on a level, dry surface in the room. in a natural way – in the same was that air is washed by • Pay proper attention to easy accessibility and sufficient the rain in nature. space for servicing and cleaning the unit.
Description of the appliance Adjusting the cable length The overall length of the cable is approx. 2 m, but this can be adjusted as required. Cover • Switch the appliance off and remove the power plug from the mains socket. Do not pull on the cable (14). • Open the cover (15 and 16) Control panel 1. Insert the screwdriver (into the hole provided) 2. Press outwards Upper part 3. Push upwards • Pull the cable from the cable compartment (17) Air outlet • Adjust the cable length by pulling/pushing • Store the remaining cable in the cable compartment • Close the cover (18) 1 disk pack with 16 humidifying discs Water tank Water tank cap Ionic Silver Stick...
• Do not pressurise the water tank, e.g. by filling it with about removing the disks, refer to section „Cleaning the carbonated mineral water. humidifying disks“. • Connect the mains cable to the mains and switch the appliance on. The 2055D (digital) unit is fitted with an automatic cut off switch. As soon as the water base is empty, the unit switches off automatically. The empty indicator illuminates (also see section “Operation 2055D”). This function is not available on the 2055 unit.
Page 8
Water quality maintenance Operating 2055 Operating 2055D The innovative Ionic Silver Stick (25) uses the proven anti ® bacterial properties of silver, thereby keeping the water free of bacteria and germs. The ISS gives off silver ions into the water over a period of more than one year. It is self renewing and requires no maintenance. The position of the ISS in the appliance can be seen in Fig. 25. First, switch the unit off. A) Rotary switch A) Switching on/off Connect the appliance to the mains and turn rotary switch Turn rotary switch A from the OFF position to position H or A to position C or D as required. To switch the appliance off, G as required. Position H is especially quiet (night mode). turn the rotary switch to position B. Position G (normal mode) achieves maximum humidity output. As soon as the appliance is switched on, the display...
Cleaning/maintenance to show the current value (CURRENT) (E). Upon reaching Warning: When lifting the upper part off the base, the ap- the desired relative humidity, the unit automatically swit- pliance also switches off. In this case, the red blinking F Switch the appliance off and remove the power ches off (display shows DESIRED and CURRENT) (E). If the symbol will also appear on the display. Only when the upper plug from the mains socket before you clean the desired relative humidity falls, the appliance automatically part is replaced on the base does symbol F go out and the appliance (26). switches on again. appliance continues operating. • Regular cleaning is a precondition for hygienic, trouble Quick display of current relative humidity free operation. When the unit is switched off (mains cable is connected, • The appliance can be disassembled for cleaning in a rotary switch to OFF setting), the current relative humidity few moves. can be shown in the display by briefly pressing one of the • Never submerse the entire unit in water (28). B buttons. This display automatically goes out after a few • The unit must be completely emptied and cleaned, if seconds. it has been filled with water for longer than a week without being used.
Page 11
Cleaning the water tank and base (every 2 weeks) • Lift the water tank out of the unit, open the water tank cap and clean the tank (33 – 35). • Lift the upper part of the unit off the base and remove the Ionic Silver Stick (36). ® • Fill the base with water, pour in a commercial decalcifi- cation agent and allow to work; Rotate the disk assembly a few times by hand (37). • Empty the water base (38), remove the disk assembly (39) and rinse (40). • Remove deposits from the base using a plastic or wooden brush and a diluted, commercial washingup detergent (41). Cleaning the humidifying disks (every 4 weeks) A thin film of lime scale on the disks actually increases the humidity output! To clean, unscrew the individual humidify- ing disks from each other. Rotary locks (toothed wheels)
Storing the appliance when not in use for Technical specifications Spare parts an extended period The spare parts depicted in the “Description of the ap- Clean the appliance as described, allow to dry completely Mains voltage 230 V / 50 Hz pliance” section can be obtained from your specialist and store it in a dry place, preferably in the original packa- dealer and installed in the unit by yourself. Only original Power consumption 20 W ging and away from excessive heat. Remove the bayonet...
Page 14
BONECO is a brand name of PLASTON AG, Switzerland.
Need help?
Do you have a question about the 2055 and is the answer not in the manual?
Questions and answers