4. USB STORAGE INFORMATION
REGISTRATION
USB storage data is important for when the camera is con-
nected to a computer via a USB connection.
If there are any errors in the USB storage data, or if it has not
been saved, the USB specification conditions will not be sat-
isfied, so always check and save the USB storage data.
Preparation:
POWER switch: ON
Adjustment method:
1. Connect the camera to a computer. (Refer to 3-5. Con-
necting the camera to the computer on the page 13.)
2. Double-click on the DscCalDi.exe.
3. Click on the Get button in the USB storage window and
check the USB storage data.
VID: SANYO
PID: J4
Serial:
Rev. : 1.00
4. Check the "Serial" in the above USB storage data. If the
displayed value is different from the serial number printed
on the base of the camera, enter the number on the base
of the camera. Then click the Set button.
5. Next, check VID, PID and Rev. entries in the USB storage
data. If any of them are different from the values in 3. above,
make the changes and then click the corresponding Set
button.
Calibration
Upload
R Bright
AWB
Firmware
Focus
RGB Offset
Image
UV Matrix
Tint
Cal Mode
Initialize
OK
EVF
VCO
H AFC
Cal Data
LCD Type
OK
USB storage
VID
Get
Set
Serial
PID
Set
LCD
B Bright
VCOMDC
Gain
VCOMPP
Phase
Test
Setting
Language
Set
Video Mode
Set
Rev.
Set
Factory Code
– 17 –