Turning On The Power; Selecting The Sources And Starting Play; Adjusting The Volume - JVC CA-UXL36V Instructions Manual

Turning On the Power

When you press the play button—CD 3/8, TAPE 2 3,
FM/AM and AUX/MD, the unit automatically turns on and
starts playback if the source is ready.
To turn on the unit, press
STANDBY/ON .
The STANDBY/ON lamp lights
green and "HELLO" appears on the
display.
To turn off the unit (on standby),
press STANDBY/ON again.
The STANDBY/ON lamp lights red
and "GOOD BYE" appears on the
display.
• "0:00" flashes on the display until you set the built-in
clock. After setting the clock, the clock time will appear on
the display while the unit is on standby.
• A little power is always consumed even while the unit is on
standby.
To switch off the power supply completely, unplug the AC
power cord from the AC outlet.
When you unplug the AC power cord or if a power
failure occurs
The clock is reset to "0:00" right away, while the tuner preset
stations (see page 12) will be erased in a few days.

Selecting the Sources and Starting Play

To play back CDs, press CD 3/8. (See pages 15 – 18.)
To play back tapes, press TAPE 2 3. (See page 23.)
To listen to FM/AM broadcasts, press FM/AM. (See pages
12 – 13.)
To select the external equipment as the source, press
AUX/MD.
CD TAPE
When you press the play button for a particular source
(CD 3/8, TAPE 2 3, FM/AM and AUX/MD), the unit turns
on (and the unit starts playing the source if it is ready).
STANDBY/ON
STANDBY / ON
STANDBY/ON
STANDBY / ON
FM/AM AUX/MD
– 10 –

Adjusting the Volume

You can adjust the volume level only while the unit is turned
on. The volume level can be adjusted between "VOL MIN"
and "VOLUME 1" – "VOLUME 40 (VOL MAX)."
When using the remote control, press
VOLUME + to increase the volume or press
VOLUME – to decrease it.
When using the unit, turn VOLUME + / –
clockwise (+) to increase the volume or
counterclockwise (–) to decrease it.
For private listening
Connect the headphones to the PHONES jack. No sound comes out
of the speakers. Be sure to turn down the volume before connecting
or putting on headphones.
DO NOT turn off (on standby) the unit with the
volume set to an extremely high level; otherwise, a
sudden blast of sound can damage your hearing,
speakers and/or headphones when you turn on the
unit or start playing any source next time.
REMEMBER you cannot adjust the volume level
while the unit is on standby.
Continued
VOLUME
VOLUME
– +