3-11) Installation - Samsung RS265 LAWP Service Manual

3. OPERATING INSTRUCTIONS & INSTALLATION

3-11) Installation

Removing Doors
Open the freezer and refrigerator doors, and
then take off the front leg cover assembly by
turning the three screws counter-clockwise.
Remove the screw from clamp, disconnect the
water tube by pressing the coupler, and pulling
the water tube away.
With the door closed, remove the upper hinge cover
using a screwdriver, and then disconnect the wires.
Remove hinge screws and ground screw counter-
clockwise, and take off the upper hinge. Take care
removing the door to ensure that it does not fall on you.
Remove the door from the lower hinge by carefully lifting
the door so as not to damage the water tube. Remove
the lower hinge from the lower hinge bracket by lifting
the lower hinge.
1) To protect refrigerator in movement
Use padded hand truck as shown. If entrance width is
less than 39 , remove doors prior to installation and
reattach doors according to procedure below.
2) Remove all protective tape and pad in refrigerators.
Connect water lines and power cord. Adjust the
clearance between the doors.
3) Set the temperature control to the temperature and
wait for an hour.
The refrigerator should get slightly chilled and the motor
runs smoothly.
4) Once the refrigerator temperature is sufficiently low
You can store food in the refrigerator. After starting the
refrigerator, it takes a few hours to reach the appropriate
temperature.
Attaching Doors
Insert the lower hinge in the bracket lower
hinge. Attach the freezer door by inserting the
hose in the lower side of the door into the hole
in the lower hinge and pulling the hose down.
Insert the upper hinge shaft into the hole. After
leveling between the upper hinge hole and the
hole of the cabinet. Reattach hinge screws and
ground screw in the clockwise direction.
Connect the wires. (Put the front part of the
upper hinge cover on the front part of the
upper hinge and reattach from the front part
of the upper hinge cover first. )
26