Mercury Monami Owner's Handbook Manual page 22

9. TROUBLESHOOTING AND SPECIFICATION
TROUBLESHOOTING
You can inspect the scooter using the checklist below before consulting your dealer. If you cannot solve
the problem by yourself contact your dealer.
Symptom
The scooter will not switch on.
The scooter switches on, but the
scooter will not move.
The scooter appears slow.
The seat turns when in operation
The tiller handlebar appears loose
Horn sounds involuntarily and
power eye flashes (this means the
scooter has automatically detected
a fault and will not drive)
Power eye flashes whilst driving.
Wheeltech Monami and Vitesse electric scooters
Owner's Handbook
Remedy
• Recharge the batteries.
• Check / reset the circuit breaker in the scooter.
• Check the battery and loom connections.
• Ensure there is enough power in the batteries. If not, recharge the
batteries.
• Ensure the freewheel lever is engaged in the DRIVE position.
• Check the battery power level and recharge.
• Check the speed dial is not set to slow
• Check the indoor / outdoor switch setting (Vitesse and Vitesse 8)
• Slowly rotate the seat until it drops in to place and is secure
• Tight the tiller adjustment handle to secure the handlebar.
• Ensure the wigwag paddle is released.
• Switch the scooter off and on using the ignition key.
• Recharge the battery.
• If the problem persists, contact your dealer.
• Control box has detected that battery voltage is below volts (low
power). Fully recharge as soon as possible.
Part Code: Z40961-00 (Rev B)
Page 21 of 24