Honeywell ZSTAT Programming Instructions

Thermostat

Basic Programming for the Honeywell ZSTAT Thermostat and 5800ZBRIDGE

Notes before you begin:

• If you need help wiring your thermostat, please call 1-800-468-1502

o If required please have a licensed professional install your product for you.

1. Press System:

Used the following buttons to program:

Use the Up and down

arrows to scroll through the

questions (fields).

2. Press the 3

and 5

- 1 -

buttons simultaneously

Use the Up and

down arrows to

enter the desired

value.

Tech Support

Updated 6/7/11

Table of Contents

Need help?

Do you have a question about the ZSTAT and is the answer not in the manual?

Page 1 Basic Programming for the Honeywell ZSTAT Thermostat and 5800ZBRIDGE Notes before you begin: • If you need help wiring your thermostat, please call 1-800-468-1502 o If required please have a licensed professional install your product for you. Programming the thermostat: 1.
Page 2 3. Arm and disarm the control panel. a. The LED will now show status of the panel. Enrolling the Z-Bridge Module into the Honeywell Z-wave thermostat: 1. Navigate through the programming of the thermostat until you reach the following screen:...
Page 3 2. Next power up the Z-Bridge with the supplied 12v power supply. a. Upon power up the yellow LED will flash 3 times. 3. Press the corresponding switch (1-4) for 1 second then release for any combination of four Thermostats or Lights. a.