Installation Of Decorative Panel - LG CEILING CASSETTE TYPE AIR CONDITIONERS Installation Instructions Manual

7. Installation of Decorative Panel

The decorative panel has its installation
direction.
1. Temporarily fix two decorative panel fixing screws (hexagon M5 screw) on the unit body. (Tighten by amount
10mm in length.)
The fixing screws (hexagon M5 screw) are included the decorative panel box.
2. Remove the air inlet grille from the decorative panel. (Remove the hook for the air inlet grille cord.)
3. Hook the decorative panel key hole (
screws reach the key hole edge.
4. Retighten completely two temporarily fixed screws and other two screws. (Total 4 screws)
5. Connect the louver motor connector and display connector.
6. After tightening these screws, install the air inlet grille (including the air filter).
Air conditioner unit
Decorative panel fixing screws
(hexagon M5 screws)
Temporally fitting at 2 places
(Tightening about 10mm)
Inlet Grille
Louver motor
Decorative panel
Inlet Grille Inlet Grille
) on the screws fixed in step above, and slide the panel so that the
Piping side
Key holes
Decorative panel fixing screws
(Hexagon M5 screw)
12
Before installing the decorative panel,
always remove the paper template.
Install the panel after
making sure that the
piping side of the unit body
matches the piping
indication of the decorative
panel
Control box cover
The arrow (
to the side where the pipes are.
) should point
Display
Lead wire for
louver motor and
display