Cleaning Filters - LG LS091HSV3 Owner's Manual

• Use two hands when lifting the front panel away from the indoor unit.
• Maintain a grip on the front panel at all times while removing filters.
air filter - cleaning/Maintenance
Clean the indoor unit air filter at least once every 2 weeks or more
often if necessary. Single zone wall mount systems have two filter
screens.
1. Turn off the power and unplug the power cord.
2. Open the indoor unit front cover by lifting up both sides of the
cover slightly. Refer to Figure 16.
Figure 16: Lifting Indoor Unit Front Panel
Front
Panel
3. Grasp the knob/tab at the bottom of the air filter, lift up slightly
and slide it from the indoor unit. Refer to Figure 17.
Figure 17: Removing the Filter
Filter Removal
4. Clean the filter with a vacuum cleaner or with warm water. If the
dirt is difficult to remove, wash the filter in luke warm water with
detergent.
5. Completely dry the filter before placing it back into the unit.
6. Replace the filter by sliding it back into the unit. While grasping
the bottom knob/tab, lower the filter back into the unit.
7. Close the front panel of the indoor unit.
3M Micro
Protection Filter
Due to our policy of continuous product innovation, some specifications may change without notification.
©
LG Electronics U.S.A., Inc., Englewood Cliffs, NJ. All rights reserved. "LG" is a registered trademark of LG Corp.
3M Micro Protection filter - cleaning/
Maintenance
Clean the indoor unit 3M Micro Protection Filter once a month or
more often if necessary. The 3M Protection Filter is located behind
the indoor unit's right-hand side air filter.
1. Turn off the power and unplug the power cord.
2. Open the indoor unit front cover by lifting up both sides of the
cover slightly. Refer to Figure 16.
3. Remove the right-side air filter as instructed in the Air-Filter -
Cleaning/Maintenance instructions.
4. Remove the 3M Micro Protection Filter by popping it out of its
holding tray within the unit. Refer to Figure 18.
Figure 18: Removing the 3M Filter
5. Use a vacuum cleaner to remove dirt from the filter.
6. Replace the filter by sliding it back into the holding tray.
• Do not wash the 3M Micro Protection Filter with water. It will
damage the filter.
• We suggest changing the 3M Micro Protection Filter once every
6 months.
• The location of the filter may differ depending on the model.
• Contact your installing contractor to obtain additional filters.
Maintenance

Cleaning Filters

19