Common Operations; Turning On Or Off The Power; Setting The Clock - JVC CA-MXG50 Instructions Manual

Common Operations

Turning On or Off the Power

To turn on the unit, press
STANDBY/ON so that the STANDBY
lamp goes off.
To turn off the unit (on standby), press
STANDBY/ON again so that the
STANDBY lamp lights up.
A little power is always consumed even while the unit is on
standby.
To switch off the power supply completely, unplug the AC
power cord from the AC outlet.
When you unplug the AC power cord or if a power
failure occurs
The clock is reset to "– – : – –" soon, while the tuner preset stations
(see page 12) will be erased in a few days.

Setting the Clock

Before operating the unit any further, first set the clock built
in this unit. You can set the clock whether the unit is on or
off.
On the unit ONLY:
1
Press CLOCK/TIMER.
2
Press 4 or ¢ to adjust the
hour, then press SET.
• If you want to correct the hour after pressing SET,
press CANCEL. The hour digits start flashing
again.
STANDBY
STANDBY/ON
STANDBY
STANDBY/ON
CLOCK
/ TIMER
The hour digits start
flashing on the display.
PRESET
SET
– 9 –
3
Press 4 or ¢ to adjust the
minute, then press SET.
To check the clock time
Press DISPLAY while playing any source.
• Each time you press the button, the source
indication and the clock time alternate on the
display.
To adjust the clock again
If you have adjusted the clock before, you need to press
CLOCK/TIMER repeatedly until "CLOCK" is selected.
• Each time you press the button, the clock/timer setting
modes change as follows:
DAILY ON TIME
Canceled CLOCK
If there is a power failure
The clock loses the setting and is reset to "– – : – –." You need to set
the clock again.
PRESET
SET
DISPLAY
REC
ON TIME