Using Recording Timer - JVC CA-MXG50 Instructions Manual

6
When you have selected "TUNER
FM" or "TUNER AM" in step 5.
Select a preset station number.
Press 4 or ¢ to select the preset
station number, then press SET.
The unit enters volume setting mode.
7
Press 4 or ¢ to set the
volume level.
• You can select the volume level from
VOL MIN, VOL 1 — VOL 30, and
VOL MAX.
8
Press SET to complete the Daily
Timer setting.
The DAILY (daily timer) indicator stops
flashing and remains lit. The settings you have
done are shown on the display in sequence for your
confirmation.
9
Press STANDBY/ON to
turn off the unit (on standby)
if you have set the Daily Timer
with the unit turned on.
If the unit is turned on when the timer-on time comes
Daily Timer does not work.
To turn on or off Daily Timer after its setting is done
1 Press CLOCK/TIMER repeatedly until
"DAILY" appears on the display.
2 To turn off the Daily Timer, press
CANCEL.
The DAILY (daily timer) indicator goes off
from the display ("OFF" appears for a while).
The Daily Timer is canceled, but the setting
for the Daily Timer remains in memory.
To turn on the Daily Timer, press SET.
The DAILY (daily timer) indicator lights up on
the display. The settings you have done are
shown on the display in sequence for your
confirmation.

Using Recording Timer

PRESET
With Recording Timer, you can make a tape of a radio
broadcast automatically. You can set the timer whether the
unit is on or off.
How Recording Timer actually works
SET
The unit automatically turns on, tunes into the specified
station, sets the volume level to "VOL MIN," and starts
recording when the on-time comes (the
while the timer is operating). Then, when the off-time comes,
PRESET
the unit automatically turns off (stands by).
The timer setting remains in memory until you change it.
• There is a time limit in doing the following steps. If the
setting is canceled before you finish, start from step 1
again.
• If you have made a mistake while setting the timer, press
CANCEL. (However, this does not always work. If
CANCEL does not work, press CLOCK/TIMER repeatedly
and start from step 1 again.)
On the unit ONLY:
1
Put a recordable cassette into deck B.
2
SET
Press CLOCK/TIMER repeatedly
until "REC" appears on the
display.
(recording timer) indicator also starts flashing on the
display.
STANDBY
STANDBY/ON
• Each time you press the button, the timer setting modes
change as follows:
CLOCK
/ TIMER
3
Press CLOCK/TIMER again.
CANCEL
"ON TIME" appears for 2 seconds, then the
/DEMO
unit enters on-time setting mode.
SET
– 21 –
indicator lights up and the REC
DAILY ON TIME
Canceled
CLOCK
(See page 9.)
indicator flashes
CLOCK
/ TIMER
REC
ON TIME
CLOCK
/ TIMER