Operating Instructions; Using The Work Lights; Jump Starting A Vehicle; Using The Air Compressor - CEN-TECH 60703 Owner's Manual

Operating Instructions

Using the Work Lights

1. To turn the Work Lights on, push the Work
Lights Switch to the "I" (ON) position.

Jump Starting a Vehicle

Note: Read the vehicle owner's manual pertaining
to jump starting prior to using the Power Pack.
1. Press the Battery Test Button to verify that the
Power Pack is fully charged. Recharge as needed,
following the instructions in the Setup section under
"Charging the Power Pack" on page 7.
2. Turn off the vehicle ignition switch and all
accessories (lights, radio, climate control, etc.).
3. Turn all switches on the Power
Pack to their OFF positions.
WARNING! DO NOT TOUCH POSITIVE AND
NEGATIVE BATTERY CLAMPS TOGETHER.
3. Connect the red Positive Battery Cable to
vehicle's positive battery terminal. Connect
the black Negative Battery Cable to a non-
moving metal part of the vehicle.

Using the Air Compressor

1. Press the Battery Test Button to verify that the
Power Pack is fully charged. Recharge as needed,
following the instructions in the Setup section under
"Charging the Power Pack" on page 7.
2. Open the Air Hose Compartment on the
back of the unit and pull out the air hose.
3. Check the proper inflation level for the object that is
being inflated.
Tire Inflation
1. Position the Tire Inflator over the valve stem and
push down firmly, making sure it is fully seated.
2. Press down the lever. (See Figure F.)
Page 10 For technical questions, please call 1-888-866-5797.
2. To turn the Work Lights off, push the Work
Lights Switch to the "O" (OFF) position.
WARNING! DO NOT CONNECT TO THE
NEGATIVE TERMINAL OF THE BATTERY.
4. The Connection Indicator Light will illuminate
green if a correct connection has been made.
If the Connection Indicator Light illuminates
red, review and change the connections.
5. When the correct connection has been made, turn
the Clamp Power Switch to the ON position.
6. WAIT FIVE MINUTES, then start the
vehicle. If the vehicle does not start, wait an
additional 3 minutes before trying again.
WARNING! THE VEHICLE WILL NOT START IF
YOU DO NOT WAIT AT LEAST 5 MINUTES.
7. After the vehicle is started, turn the Clamp
Power Switch to the OFF position. Remove
the black Negative Battery Cable first, and
then the red Positive Battery Cable.
Adapter
installed
Air Hose
Figure F
3. Push the Compressor Switch to the "I" (ON) position.
Note: Monitor the Air Pressure Gauge on the
front of the unit to avoid over-inflation.
4. When the proper inflation level has
been reached, push the Compressor
Switch to the "O" (OFF) position.
5. Lift the lever and remove the hose.
Tire Inflator
Lever
pressed
down
Item 60703