JVC CA-MXDK1 Instructions Manual page 8

For the Australian model
Stereo mini plug
(not supplied)
@
Subwoofers (for CA-MXDK5 and MX-DK3)
• MX-DK3 has only one subwoofer.
• When connecting the speaker cords, match the polarity of
the speaker terminals: (+) to (+) and (–) to (–).
CA-MXDK5
From right
subwoofer
MX-DK3
From the subwoofer
• Use only speakers with the same speaker impedance as
indicated by the speaker terminals on the rear of the unit.
5
¤
From left surround
speaker (not supplied)
• The surround speakers connected can reproduce the bass
sounds recorded in front left and right channels, but cannot
reproduce the surround signals recorded in DVD multi-
channel discs.
#
• When connecting the speaker cords, match the polarity of
the speaker terminals: (+) to (+) and (–) to (–).
main speaker
• Use only speakers with the same speaker impedance as
indicated by the speaker terminals on the rear of the unit.
From left
• The speakers are magnetically shielded to avoid color
subwoofer
distortions on TVs. However, if not installed properly, it
may cause color distortions. So, pay attention to the
following when installing the speakers.
– When placing the speakers near a TV set, turn off the TV's
main power switch or unplug it before installing the
speakers.
Then wait at least 30 minutes before turning on the TV's
main power switch again.
Some TVs may still be affected even though you have
followed the above. If this happens, move the speakers away
from the TV.
Surround speakers (for CA-MXDK5 and
MX-DK3)
From right surround
speaker (not supplied)
Main speakers
From right
• DO NOT connect more than one speaker to
each terminal.
• DO NOT push or pull the speakers as this
will damage the foot spacers at the bottom
of the speakers.
From left
main speaker