JVC CA-MXDK1 Instructions Manual page 7

~
AM/FM antenna
To assemble the AM loop antenna
To connect AM/FM antenna
FM antenna (supplied)
Extend it so that you can
obtain the best reception.
AM loop antenna
(supplied)
Turn it until the best
reception is obtained.
For better AM/FM reception
FM outdoor antenna
(not supplied)
AM loop antenna (supplied)
Keep it connected.
Vinyl-covered wire (not supplied)
Extend it horizontally.
• Disconnect the supplied FM antenna, and connect to an
outdoor FM antenna using a 75
connector (IEC or DIN45325).
• Make sure the antenna conductors do not touch any other
terminals, connecting cords or the power cord. Also, keep
the antennas away from metallic parts of the System,
connecting cords, and the AC power cord. This could cause
poor reception.
Ω
wire with coaxial type
Ÿ
TV/monitor
Green
Blue
Red
Component
video cord
(not supplied)
S-video cord
(not supplied)
• Connect the VIDEO jack, S-VIDEO jack, or
COMPONENT jacks (CA-MXDK5 only) whichever you
want to use.
• To select progressive scanning mode (see page 6), use
COMPONENT jacks (CA-MXDK5 only).
• To select the video output to match the color system of your
TV (PAL or NTSC), see page 6.
!
Digital audio component
Protective cap
• Set "DIGITAL AUDIO OUTPUT" in the "AUDIO"
preference display correctly according to the connected
digital audio equipment (see page 35). If setting is incorrect,
loud noise may be generated causing damage to the
speakers.
Digital audio signals are output from this System only when
"DVD/CD" is selected as the source.
⁄
Auxiliary equipment
Red
Stereo audio cord
(not supplied)
Composite video
cord (supplied)
White
Continued on the next page...
4