LG StudioWorks 563N Service Manual page 10

14) Set Brightness and Contrast to Max position.
15) Set SUB-CONTRAST Max 127(7F) (decimal) position.
16) Set B-DRIVE to 100(64) at DRIVE of the alignment
program.
17-1) Adjust R-DRIVE and G-DRIVE command to white
± 0.003 and y=0.298 ± 0.003 on the
balance x=0.283
White Balance Meter with PC arrow keys.
17-2) Display color 15,0 window pattern (70x70mm) at mode 4.
18) Adjust SUB-CONTRAST command to 50
19) Display color 15,0 full white patten at Mode 4.
20) Set Brightness and Contrast to Max position.
21) COLOR ADJ. → LUMINANCE → ABL command.
22) Adjust ABL to 32 ± 1FL of the luminance.
23) After push the "ENTER" key, and "COMMAND →
PRESET EXIT → Y(Yes)" command.
24) Exit from the program.
5. Input EDID Data.
1) Display color 15,0 cross hatch pattern at Mode 4.
2) EEPROM → Write EDID command and confirm
"EDID Write OK!!" message of monitor.
3) Exit from the alignment program.
4) Power switch OFF/ON for EDID data save.
6. Adjustment for Focus.
1) Set the Brightness and Contrast to max position.
± 2FL .
2) Display H character in full screen at Mode 4.
3) Adjust two Focus control on the FBT that focus
should be the best condition.
- 10 -