After Start-Up; Spring, Fall And Winter Operation - Pentair MASTERTEMP 125 Installation And User Manual

Section 6. Maintenance
46

AFTER START-UP

CHECKING WATER FLOW
Fire or flooding hazard. If the unit overheats and the burner fails to shut off, follow instructions under "To Turn Off Gas to the
Appliance", page 33, and call a qualified service technician to repair unit.
SPRING AND FALL OPERATION
WINTER OPERATION
damage the heater and void the warranty.
Water trapped in the heat exchanger can result in freeze damage to the exchanger or headers. Freeze damage is specifically
not covered by the warranty.
to heat the water; however, make sure that the heater operates continuously until the water temperature reaches the
heater's minimum setting of 68° F (20° C). During cold weather, if there is no danger of freezing, operate the filter pump
continuously even if the heater is not operating. If air temperatures are expected to drop below freezing (32° F/0° C), shut
down the heater and winterize it.
Explosion hazard. Purging the system with compressed air can cause components to explode, with risk of severe injury or death
to anyone nearby. Use only a low pressure (below 5 PSI or 35 kPa), high volume blower when air purging the heater, pump,
filter, or piping.
NOTICE: Water trapped in the heater can cause freeze damage. Allowing the heater to freeze voids the warranty.
(See additional notes under Important Notices in Introduction.)
MASTERTEMP ® 125 Pool and Spa Heater Installation and User's Guide
WARNING
CAUTION
F. (20° C) will cause harmful condensation and will
WARNING
Rev. B 8/14