Component Identification - Landa SLT Operator's Manual

Water Inlet
Pump — Delivers a specific gpm to the high pressure
nozzle which develops pressure.
Spray Gun — Controls the application of water and
detergent onto cleaning surface with trigger device.
Includes safety latch.
Detergent Valve — Allows you to siphon and mix
detergents.
Wand — Must be connected to the spray gun.
High Pressure Hose — Connect one end to water
pump high pressure discharge nipple and the other
end to spray gun.
6

COMPONENT IDENTIFICATION

Wand
Generator
Landa SLT/SLX Diesel • 8.914-003.0 • Rev. 12/11
Rupture Disk
Pressure
Nozzles
Pump
Unloader
Pump
Spray
Rupture Disk — Secondary pressure release in the
unlikely event the unloader valve fails.
Unloader Valve — Safety device which, when the
spray gun closes, prevents over pressurization.
Generator — Provides 110V power to the burner
assembly.
NOTE: If trigger on spray gun is released for more
than 2 minutes, water will leak from the pump
protector. Warm water will discharge from pump
protector onto floor. This system prevents internal
pump damage.
High
Thermostat
Volt
Meter
Detergent
Valve
Gun
High
Pressure
Hose