Page 1
UI NA T CA TÁ ÑO R LO IE S E L’A S BL IO NA SÉ EI L T EN ÉR IO N 98075400-1 For technical assistance or the dealer nearest you, consult our web page at www.landa.com 9.807-540.0...
Page 2
SYMBOLS Identification of Operational Label Symbols Hour Meter Pump Switch Burner Switch Steam Combination Detergent Voltage When the light is on, it means the power supply is on Temperature When the light is on, it means the engine is overheating. Turn machine off and perform maintenance.
The model and serial numbers will be found on a decal attached to the pressure washer. You should record both serial number and date of purchase and keep in a safe place for future reference. Landa SLT/SLX Kubota Diesel Operator Manual • 9.807-540.0 • Rev. 6/13...
SPRAY AWAY FROM utility company or the selling ELECTRICAL WIRING. fuel should the equipment be exposed to a distributor for specific details. higher ambient temperature. Landa SLT/SLX Kubota Diesel Operator Manual • 9.807-540.0 • Rev. 6/13...
Failure to do this could USING LADDER. result in injury from a whipping wand. 14. Never make adjustments on machine while in operation. TRIGGER GUN KICKS BACK - HOLD WITH BOTH HANDS Landa SLT/SLX Kubota Diesel Operator Manual • 9.807-540.0 • Rev. 6/13...
Page 6
28. In oil burning models, use only kerosene, No. 1 home heating fuel, or diesel. If diesel is used, add a soot remover to every tankful. Follow the maintenance instructions speci- fied in the manual. Landa SLT/SLX Kubota Diesel Operator Manual • 9.807-540.0 • Rev. 6/13...
High Pressure Hose — Connect one end to water protector onto floor. This system prevents internal pump high pressure discharge nipple and the other pump damage. end to spray gun. Landa SLT/SLX Kubota Diesel Operator Manual • 9.807-540.0 • Rev. 6/13...
Keep proper fuel in proper tank. attached to the positive terminal. Use a 12V group 24 style battery. Landa SLT/SLX Kubota Diesel Operator Manual • 9.807-540.0 • Rev. 6/13...
NOTE: For a more gentle rinse, select the white 40° or green 25° nozzle. To scour the surface, select the yellow 15° or red 0° nozzle. Landa SLT/SLX Kubota Diesel Operator Manual • 9.807-540.0 • Rev. 6/13...
3. Pour about one teaspoon of engine oil through the nance of the engine. spark plug hole, pull the starter grip several times Landa SLT/SLX Kubota Diesel Operator Manual • 9.807-540.0 • Rev. 6/13...
Test transformer for proper arc between contacts. Replace as needed. (continued on Disconnected or short in All wire contacts should be clean and tight. next page) electrical wiring No breaks in wire. Landa SLT/SLX Kubota Diesel Operator Manual • 9.807-540.0 • Rev. 6/13...
Page 13
Misaligned electrode setting Realign electrodes to specifications. Obstruction in smoke stack Check for insulation blockage or other foreign objects. Low engine RPM Increase RPM. Landa SLT/SLX Kubota Diesel Operator Manual • 9.807-540.0 • Rev. 6/13...
Page 14
Check and replace if necessary. Cracked piston Check and replace if necessary. Pump protector Lower water supply pressure. Do not run with spray gun closed longer than 2 minutes. Landa SLT/SLX Kubota Diesel Operator Manual • 9.807-540.0 • Rev. 6/13...
Page 15
Defective control switch Replace switch. Loose wire Check and replace or tighten wiring. Defective burner motor Replace motor. RELIEF VALVE Relief valve defective Replace or repair. LEAKS WATER Landa SLT/SLX Kubota Diesel Operator Manual • 9.807-540.0 • Rev. 6/13...
Turn the engine on to siphon the anti-freeze mixture through the machine. If com- pressed air is available, an air fitting can be screwed Landa SLT/SLX Kubota Diesel Operator Manual • 9.807-540.0 • Rev. 6/13...
Page 18
The use of aviation fuels - JP4, JP5 or JP8 must be approved on an application basis and is not rec- Continued next page ommended for broad range commercial applications. Landa SLT/SLX Kubota Diesel Operator Manual • 9.807-540.0 • Rev. 6/13...
Page 19
5. Remove fittings connected to the 1/2" pipe nipples exhaust is being emitted from the stack, two things from inlet and discharge sides of coil. should be checked. First, check the fuel to be certain Landa SLT/SLX Kubota Diesel Operator Manual • 9.807-540.0 • Rev. 6/13...
Page 20
9. Replace or repair any insulation found to be torn or broken. 10. Remove insulation retainer plates. Coil Reinstallation: To reinstall new or cleaned coil, reverse steps 9 through 1. Landa SLT/SLX Kubota Diesel Operator Manual • 9.807-540.0 • Rev. 6/13...
3 months or 500 hours thereafter. Use SAE 10/40W non-detergent. Date Oil Changed No. of Operating Hours Brand Name and Month/Day/Year Since Last Oil Change Type of Oil (See above) Landa SLT/SLX Kubota Diesel Operator Manual • 9.807-540.0 • Rev. 6/13...
Page 22
Authorized LANDA Dealer of the defect. Your Authorized LANDA Dealer will file a claim with Landa, who must subsequently verify the defect. In most cases, the part must be returned to LANDA freight prepaid with the claim. For warranty service on components warranted by other manufacturer’s, your Authorized LANDA Dealer can help you obtain warranty service through these manufacturers’...
Page 24
Form #9.807-540.0 • Revised 6/13 • Printed in U.S.A.