Table of Contents
Advertisement
Wall mounting
Plate is flush with
backside of
clock—"feet" are
hidden.
1.
Locate the keyhole slots on the back of the clock, at either end. The slots
are placed six inches apart (See Figure 1: Serial Clock—Rear Panel on
page 7).
2.
Install two #8 screws into the wall/mounting surface, six inches apart.
Use the type of screws and anchoring methods appropriate for the
mounting surface. For example, use wood screws if you are mounting to
a wood surface. (These screws are not supplied.) Make sure that the
heads of the screws are placed at least 3/8 of an inch from the wall.
3.
Insure that the plate and the feet are facing in, towards the backside of
the clock (See Figure 4: Serial Clock—Side View).
4.
Hang the clock on the two screws located on the wall/mounting surface,
using the keyhole slots.
Countertop or desk mounting
1.
Remove the screw and plate on the backside of the clock (See Figure 1:
Serial Clock—Rear Panel on page 7).
2.
Turn the plate over so that the "feet" protrude out (away) from the
backside of the clock (See Figure 4: Serial Clock—Side View). The
plate can be adjusted up or down to obtain the desired viewing angle.
3.
Replace the screw and stand the clock upright.
Wall Mounting
Figure 4: Serial Clock—Side View
ALPHA Serial Clock Manual
Countertop Mounting
Plate is
reversed—"feet"
are facing out.
15
Advertisement
Table of Contents
