Connecting Audio/Video Components - JVC RX-7520VBK Instructions Manual

Getting Started
Connecting the rear and center speakers
Connect rear speakers to the REAR SPEAKERS terminals and a
center speaker to the CENTER SPEAKER terminals.
Center
speaker
Left rear
Right rear
speaker speaker
1 2
R IG
H T
L E
F T
For each speaker, connect the (+) and (–) terminals on the rear panel
to the (+) and (–) terminals marked on the speakers.
1 Cut, twist and remove the insulation at the end of
each speaker signal cable (not supplied).
2 Turn the knob counterclockwise.
3 Insert the speaker signal cable.
4 Turn the knob clockwise.
Connecting the subwoofer speaker
By connecting a subwoofer, you can enhance the bass or reproduce
the original LFE signals recorded on the digital software.
Powered subwoofer
Connect the input jack of a powered subwoofer to the
SUBWOOFER OUT jack on the rear panel, using a cable with RCA
pin plugs (not supplied).
• Refer also to the manual supplied for your subwoofer.
Since bass sound is non-directional, you can place a
subwoofer wherever you like. Normally place it in front of
you.
6
CENTER REAR
SPEAKER SPEAKERS
+
–
RIGHT LEFT
4
3
R IG
R IG
H T
H T
L E
L E
F T
F T
AUDIO
RIGHT LEFT
FRONT
DVD
SUB
CENTER
WOOFER
REAR
RIGHT LEFT
SUBWOOFER
OUT

Connecting Audio/Video Components

Turn off all components before connecting.
You can connect the following audio/video components to this unit.
Refer also to the manuals supplied with your components.
Audio Components
• CD player*
• Cassette deck
or CD recorder*
* You can connect these components using the methods described in
"Analog connections" (below) or in "Digital connections" (see page 9).
Analog connections
Audio component connections
Use the cables with RCA pin plugs (not supplied).
Connect the white plug to the audio left jack, and the red plug to the
audio right jack.
CAUTION:
If you connect a sound-enhancing device such as a graphic equalizer
between the source components and this receiver, the sound output
through this receiver may be distorted.
CD player
CD player
To audio output
Video Components
• VCR
• TV*
• DVD player*
CD
OUT
(REC)
TAPE
CDR
IN
(PLAY)
OUT
(REC)
VCR
IN
(PLAY)
TV SOUND
RIGHT LEFT
AUDIO