Connecting The Fm And Am Antennas - JVC RX-7520VBK Instructions Manual

Getting Started

Connecting the FM and AM Antennas

AM Loop Antenna
(supplied)
Snap the tabs on the loop
into the slots of the base
to assemble the AM loop
antenna.
If AM reception is poor, connect
outdoor single vinyl-covered wire
(not supplied).
1 2
AM antenna connection
Connect the supplied AM loop antenna to the AM LOOP
terminals.
Turn the loop until you have the best reception.
• If the reception is poor, connect an outdoor single vinyl-
covered wire (not supplied) to the AM EXT terminal. (Keep the
AM loop antenna connected.)
FM antenna connection
Connect the supplied FM antenna to the FM 75 Ω COAXIAL
terminal as a temporary measure.
Extend the supplied FM antenna horizontally.
• If the reception is poor, connect an outdoor FM antenna (not
supplied). Before attaching a 75 Ω coaxial cable (with a
standard type connector), disconnect the supplied FM antenna.
4
Outdoor FM antenna (not supplied)
If FM reception is poor, connect outdoor
FM antenna.
ANTENNA
FM 75
COAXIAL
AM
LOOP
AM
EXT
3
Notes:
• If the AM loop antenna wire is covered with vinyl,
remove the vinyl while twisting it as shown on the
right.
• Make sure the antenna conductors do not touch any
other terminals, connecting cords and power cord.
This could cause poor reception.
7 5
IA L
F M
A X
C O or
Standard type
Supplied FM
outdoor FM antenna
antenna
(not supplied)
FM antenna (supplied)
Extend the supplied FM antenna horizontally.
7 5
F M IA L
A X
C O