Run Lcd Smartie - Sure Electronics 2004 LCD SMARTIE ASSET User Manual

Overview
FIGURE 1-4 DIS[LAY SCHEMATIC AFTER POWER-UP

1.2.3 Run LCD Smartie

1. Click "Setup" at the lower left corner of the main page to perform the following
configuration (as shown in figure 1-5)
FIGURE 1-5 SIMULATION DISPLAY INTERFACE
Select "matrix.dll" from the "Display Plugin" drop-down list under "Screens" tab. Fill the
COM port name in "Startup Parameters" under "Display settings", the communication
speed is 9600bps (As shown in figure 1-6).
FIGURE 1-6 SELECT PLUG-IN AND FILL IN PORT NAME
Port name can be obtained by the following means: Right-click "My Computer" and
locate "Silicon Labs CP210x USB to UART Bridge" after Properties→Hardware→Device
Manager→Ports. The content in its following bracket is the port name.
Select "4x20" from the "LCD size" drop-down list under the "Screen" tab of Display
Settings, as shown in figure 1-7. Click "OK" or "Apply" at the lower right-hand corner to
enable communication. After that, the display on LCD will be consistent with what is
being simulated with LCD Smartie.
© 2004-2011 Sure Electronics Inc.
DE-LP14111_Ver1.1_Page 3