Vm Board 4; Picture Tube Removal - Sony TRINITRON KV-29FS60A Service Manual

2-8. PICTURE TUBE REMOVAL

Anode cap 1
Picture tube 11
• REMOVAL OF ANODE-CAP
Note : Short circuit the anode of the picture tube and the anode cap to the metal chassis, CRT shield or carbon paint on the CRT, after removing the anode.
* REMOVING PROCEDURES.
a
1
Turn up one side of the rubber cap in
the direction indicated by the arrow a
• HOW TO HANDLE THE ANODE-CAP
1 To prevent damaging the surface of the anode-cap do not use sharp materials.
2 Do not apply too great a pressure on the rubber, as this may cause damage to
the anode connector.
3 A metal fitting called a shatter hook terminal is fitted inside the rubber cap.
Do not turn the rubber foot over excessively this may cause damage if the
shatter hook sticks out.
Degaussing coils 8
Spring tension 9
C board 3

VM board 4

Neck assy 5
Deflection yolk 6
2 Using a thumb pull up the rubber cap
firmly in the direction indicated by the
arrow b
7 DGC holder
10 Four PT screws
b
b
3 When one side of the rubber cap is
19
2 Chassis assy
Cushion
c
Anode button
separated from the anode button, the
anode-cap can be removed by turning
up the rubber cap and pulling it up in
the direction of the arrow c