Table of Contents
Advertisement
After the door has been reversed, you should check the
door seal of the fridge and freezer door. Neither seal
should be creased or crushed; otherwise there will be a
gap between it and the inside of the door.
o The seal must adhere properly all the way around the door.
o If either seal is not adhering to the cabinet properly, then you
should either:-
1. Use a warm damp cloth and manipulate the seal until it does
adhere to the cabinet properly, all the way around the door.
or
2. Use a hair dryer on its lowest heat setting and lightly heat the
areas of the door seal that are not adhering correctly. The
heat will make the seal more pliable and this will allow you to
manipulate the seal into the correct position.
IMPORTANT: DO NOT HEAT THE DOOR SEAL ON ANYTHING BUT THE
LOWEST HEAT SETTING, OR HEAT THE SEAL FOR A LONG PERIOD OF
TIME. OTHERWISE DAMAGE MAY BE CAUSED TO THE DOOR SEAL,
WHICH WOULD NOT BE RECTIFIED UNDER THE GUARANTEE FREE OF
CHARGE.
IMPORTANT: WHEN YOU HAVE REVERSED THE DOORS OF THE
APPLIANCE; AS YOU HAVE PLACED THE
YOU MUST WAIT FOR 8 HOURS BEFORE SWITCHING THE APPLIANCE
BACK ON.
Troubleshooting
IMPORTANT: If your fridge freezer appears not to be
operating properly, before contacting the Baumatic
Customer Care Department, please refer to the
checklist below.
My fridge freezer does not appear to be working/there
is no power to my appliance.
o Check that the plug is fully inserted into the power socket.
o Check that there is power to your mains supply (e.g. that there
hasn't been a power cut or that the fuse hasn't blown).
o Check that your mains supply voltage, corresponds to the
voltage stated on the rating plate of your appliance.
APPLIANCE ON ITS SIDE,
30
Advertisement
Table of Contents
