Table of Contents
Advertisement
o When the connection is completed, no stray strands or cut wire
should be present. The cord clamp must be secured over the outer
sheath.
Positioning
o It is advisable that your appliance is only installed in a location
where the ambient temperature of the room, corresponds with the
climate classification that is stated on the rating plate of your
appliance. Your appliance may not function correctly if the ambient
temperature falls outside of the following ranges.
Climate classification Appropriate ambient temperature
SN
N
ST
T
o Positioning the appliance requires two persons in order to avoid
injuries or damage to the appliance.
o Your appliance should not be located in direct sunlight or exposed
to continuous heat or extremes of temperature (e.g. next to a
radiator or boiler). If this is not feasible, then you should install an
insulation plate between the appliance and the adjacent heat
source.
o You should check whether there is an electrical socket available,
which will be accessible after your appliance is installed.
o Place the appliance flatly and firmly on a solid base. The appliance
is fitted with adjustable feet on the front side, which can be used to
level the appliance.
o The rear side of the appliance is fitted with wheels which facilitate
the positioning of the appliance into its final location.
+10 to +32 degrees centigrade
+16 to +32 degrees centigrade
+18 to +38 degrees centigrade
+18 to +43 degrees centigrade
o Anything positioned above the appliance must be
at least 10 cm away to allow sufficient cooling of
the condenser. You must allow a 2 cm gap either
side of the appliance and a 5 cm gap to the rear.
o If you are placing another cooling appliance next
to this product, then there must be a gap of at
least 10 cm between the appliances. This will
help to prevent condensation from forming.
25
Advertisement
Table of Contents
