Sanyo PLC-XF60 Service Manual page 33

Optical adjustment
z Integrator-in angle adjustment
Condition: Lamp 2 Mode
(Menu: Setting -> Lamp -> Mode -> 1-Lamp -> Lamp 2)
1
Remove a shutter assy from the optical unit and disconnect the FPC
cables of the panels.
2
Turn the projector on with Lamp 2 mode.
3
A
Loosen 2 screws and on the integrator-out and 2 screws
integrator-in (Fig1-1 and Fig1-2).
4
Insert a slot screwdriver into the slot-
play the color band on the top and bottom of the screen by turning
the screwdriver as shown in Fig,1-1.
5
Insert a slot screwdriver into the slot-
play the color band on the left and right of the screen by turning the
screwdriver as shown in Fig,1-2.
6
Tempolarily tighten screws
tor-in and turn the Integrator-in left or right by usind the shadow part
of the holder until the edge of the color band becomes clearest.
7
A C
Tightem screws , and
A
Fig.1-1
B
on the integrator-out and dis-
D
on the integrator-in and dis-
C
and loosen 2 screws
E
to fix the Integrator-in and out unit.
Yellow band
Blue band
B
A
Integraror-Out
Integraror-In
C
on the
E
on the Integra-
E
C
C
- 33 -
Eddge becomes clear
(Target screen image)
Blue band
Blue band
E
Fig.1-2
Yellow band
Yellow band
D