Pinnacle Systems Dekocast Technical Reference And Service Manual page 55

12. Attach the two internal ribbon cables to the RS-422 card.
The internal ribbon connections to the RS-422 card from the workstation's back-panel RS-
422 connections are as follows:
• Workstation Back-Panel RS-422A ribbon to bottom connector on RS-422 Card
• Workstation Back-Panel RS-422B ribbon to top connector on RS-422 Card
Note: The easiest way to tell which ribbon cable is which is to insert your fingers inside the back-panel
chassis to the RS-422B connector, and then trace the ribbon cable with your fingers.
13. Attach the PCI slot back-panel access plates to the workstation.
Push each workstation PCI slot back-panel access plate into place on the computer's
frame, and tighten the two spring screws of each plate to fasten. Then connect all of the
external BNC cables to the front of the BNC I/O Connection Plate.
14. Attach the Workstation Support Brace.
Put the Workstation Support Brace back in place just above the cards. Refer to Figure 5-1.
Screw the brace into place at both ends with its previously removed screws.
15. Attach all other cables and power up the computer.
Connect power cord, monitor cable, and any other communication cables that you
removed previously, and then power up the computer.
16. Place the computer's cover back on the computer.
Use a Phillips-head (+) screwdriver to reattach the screws securing the top cover to the
computer.
17. Return the damaged RS-422 Card to Pinnacle Systems.
Place the damaged Daria Bypass Card into the antistatic bag that the replacement card was
pulled from, and send the damaged card to Pinnacle Systems per the instructions given by
Pinnacle Support.
DekoCast Technical Reference And Service Guide
Chapter 5: System Maintenance
55